Gorenje WHI941ST - Инструкция по эксплуатации - Страница 26

26               

Setting of Automatic Operation parameters

For correct use of the automatic operation, perform “Hood Calibration”.

Hood Calibration

With the display on (ON) and the suction off (OFF), press button 

T3

 for 3 seconds.

The suction speed (power) 1 starts functioning and button 

T3

 flashes to indicate that hood calibration is initiated and it will last for approx. 

5 minutes.

Note: 

to interrupt the calibration, press 

T3

 for 5 seconds; the calibration will be invalidated and should therefore be repeated.

MAINTENANCE

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the 

connector and removing the connector fuse.

Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.

Cleaning

The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) inter

-

nally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products. 

DO NOT USE ALCOHOL!

WARNING:

 Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. 

Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire 

damage linked to inappropriate maintenance or failure to observe the above safety recommendations.

Grease filter

Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive detergents, either by hand or in the 

dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, 

but this does not affect its filtering capacity. To remove the grease filter, pull the spring release handle.

Charcoal filter

 (filter version only)

It absorbs unpleasant odours caused by cooking. The saturation of the charcoal filter occurs after more or less prolonged use, depending on 

the type of cooking and the regularity of cleaning of the grease filter. In any case it is necessary to replace the cartridge at least every four 

mounths. The charcoal filter may NOT be washed or regenerated.

Replacing lamps

The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum lighting, a duration up to 10 times 

as long as the traditional lamps and allow to save 90% electrical energy.

For replacement, contact the technical service.