Gorenje Plus GHT92X - Инструкция по эксплуатации - Страница 46

cloth 

 and 

 not too concentrated liquid 

detergent. Do not use abrasive substances. 

Attention! Hold the panel with both hands 
when dismantling and re-mounting in 
position to avoid it falling and causing 
damage to people or things. 
Dismantling:  

-pull the panel (FRONT SIDE) downward with 
decision,
-push to the left the small lever located on the 

right side of the panel,

-unhook it from the back hinges. 

Cleaning: 

Clean the suction panel with the same 
frequency as the fats filter using a cloth 
soaked in neutral liquid detergents.
 

Avoid the use of products containing 

abrasives. DO NOT USE ALCOHOLS.  

Montage: 

The panel must be hooked at the back and 
fixed in front fitted into the pins for the 
purpose on the surface of the hood.    

Attention! 

always check that the panel is well 

fixed in its place. 

Grease filter 

Fig. 13-25 
Traps cooking grease particles. 

This must be cleaned at least once a month 
(or when the filter saturation indication system 
- envisaged on the model in possession - 
indicates this necessity), using non-
aggressive detergents, in a dishwasher, which 
must be set to a low temperature and a short 
cycle (Tmax: 70°C). 
When washed in a dishwasher, metal parts 
may discolour slightly.  
The filter must be dried in an oven for one 
hour at a max temperature of 100°C; if the 
filter is still moist, repeat the operation. 
Replace the filter at least every 2 years. 
To remove the grease filter, pull the spring 
release handle. 

Charcoal filter (filter version only) 

Fig. 24 
It absorbs unpleasant odours caused by 
cooking. 

The saturation of the charcoal filter occurs 
after more or less prolonged use, depending 
on the type of cooking and the regularity of 
cleaning of the grease filter. 
In any case it is necessary to replace the 
cartridge at least every four mounths (or when 
the filter saturation indication system – if 
envisaged on the model in possession – 
indicates this necessity).The charcoal filter 
may NOT be washed or regenerated. 

Circular carbon filter 

Apply one on each side as cover to both the 
shield grids of the motor impeller, then turn 
clockwise. 
For the disassembly, turn counter-clockwise. 

Replacing lamps 

The hood is equipped with a lighting system 
based on LED technology. 
The LEDs guarantee an optimum lighting, a 
duration up to 10 times as long as the 
traditional lamps and allow to save 90% 
electrical energy. 

For replacement, contact the technical 
service. 

46