Gaggenau AW 201-192 - Инструкция по эксплуатации - Страница 19

For 

circulating air mode

use the installation set

included with the ventilation ducts AD 010-112/122
und AD 011-112/122. You also need an activated
charcoal filter (KF 001-010). 
Proceed as follows:

– Slightly loosen the screws of the retaining bracket

for the chimney paneling. Hang the angle pieces
onto the screws and tighten the screws.

– Screw the circulating air switch module to the

angle pieces (4 screws).

– Shorten the flexible air pipe accordingly. Fix the

flexible air pipe with hose clamps (Fig. 24).

– Establish the electrical connection.

– Stainless steel chimney only (AD 010-112/122): 

pull the protective film off the chimney’s trims.

Note:

avoid damaging the sensitive metal surfaces.

– Fit the top chimney duct unit into the base. Make

sure that the fastening holes on the side are at the
top. 

– Put both chimney duct units onto the hood. 

– Pull the top chimney duct unit up into its final

position and secure it with 2 screws on the ceiling
holder (Fig. 25).

Note: 

avoid scratches when pulling the elements

apart by placing the assembly template, for
example, over the edge of the bottom chimney
paneling to protect it. 

– Insert the activated charcoal filters.

– Insert the grease filters.

17

Fig. 24

Fig. 25