Falmec TIME 85 INOX - Инструкция по эксплуатации - Страница 20

20

OPERATION

WHEN TO TURN ON THE HOOD?

Switch on the hood at least one minute before starting to cook to con-
vey fumes and vapours towards the suction surface.
After cooking, leave the hood operating until complete extraction of all 
vapours and odours. By means of the Timer function, it is possible to set 
hood auto switch-off after 15 minutes of operation.

WHICH SPEED IS TO BE SELECTED?

1st speed:

 maintains the air clean with low electricity consumption.

2nd speed:

 normal conditions of use.

3rd speed:

 presence of strong odours and vapours.

4th speed:

 rapid disposal of odours and vapours.

WHEN SHOULD THE FILTERS BE WASHED OR REPLACED?

The metal filters must be cleaned every 30 hours of operation. 
The active carbon filters must be replaced every 3-4 months, depend-
ing on the use of the hood.
For further details see chap.

''MAINTENANCE''.

ELECTRONIC PUSHBUTTON PANEL

Motor ON/OFF

Upon start-up, the speed is that stored at the previous op-
eration.

Increase speed from 1 to 4

Speed 4 is only active for a 
few minutes, then speed 3 
activates.

The speeds are indicated by 
the LEDs on the keys:

Speed 1

 Speed 2

 Speed 3

 Speed 4 

("+" LED flashing)

Reduce speed from 4 to 1

Light on/off

Short impulse: 

turn light on and off

Long impulse: 

change light tone from 2700K to 5600K

TIMER

 (red LED flashing)

Auto switch-off after 15 min.
The function deactivates (red LED off ) if:
- The TIMER key ( ) is pressed again.
- The ON/OFF key ( ) is pressed.

 USING THE RADIO CONTROL (OPTIONAL)

WARNINGS!:

Place the hood away from sources of electromagnetic 

waves (e.g. microwave ovens), which could interfere with 

the radio control and with the hood electronics.

The maximum operating distance is 5 metres, that may vary ac-

cording to the presence of electromagnetic interferences. 

Radio control operated at 433.92MHz.

The radio control consists of two parts:

- the receiver built into the hood;

- the transmitter shown here in the figure.

DESCRIPTION OF TRANSMITTING

COMMANDS

UP

Motor switch-on and speed in-
crease from 1 to 4. Speed 4 is only 
active for a few minutes.

DOWN

Speed decrease and motor 
switch-off.

Light ON-OFF

Short impulse:

turn light on and off

Long impulse:

change light tone from 2700K to 
5600K

TIMER ON:

The motor automatically switches 
off after 15 min.
The function is automatically dis-
abled if the motor is switched off 
(

 key)

Command transmission active

ACTIVATION PROCEDURE

Before using the radio control, follow the procedure below on the 

hood pushbutton panel

:

•

  Press LIGHT ( ) and TIMER ( ) simultaneously until all LEDs start 

flashing. 

•

  Release the two keys and press LIGHT ( ) again until all LEDs are lit 

up. 

•

  Release LIGHT ( ): now the receiver is active.

This procedure is also used to deactivate the receiver.

RADIO CONTROL CODE CHANGE

With only one radio control, go directly to point 2.
With several radio controls in the same room, a new code can be creat-
ed by following the procedure below.

Disconnect the power to the hood before starting the pro-

cedure.