Falmec Quasar 120 Vetro (800) - Инструкция по эксплуатации - Страница 17

15

If the hood is of filtering type, remove the non-return valve fitted at the motor’s outlet.

For maximum efficiency, the third speed should be used when there are strong odours or a lot 
of steam, the second speed in normal conditions, and the first speed for keeping the air clean 
with minimum energy consumption. The range hood should be switched on when starting to 
cook, and left on until the odours disappear.

G

OPERATION

1.  ELECTRONIC CONTROL PANEL (Quasar Top)

Light pushbutton 

• ON: light on (the pushbutton is lit); 

• OFF: light off; 

Pushbutton -

Press to reduce motor speed 

Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and 
the timer LEDs).

Pushbutton +

Press to increase motor speed 

Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and 
the timer LEDs). 

(In the 4-speed version the pushbutton + blinks. The fourth speed remains on for a set 
duration of time. After 15 minutes the motor returns to the third speed).

Mode pushbutton

Function: it turns hood motor on and off. 

 The 

function 

“desired speed”

 enables to start the motor at the speed that was selected 

before the hood was last turned off. 

 Optional: 

version with remote control (some versions only).

WARNING: 

Install the hood away from sources of electromagnetic waves, as these could affect the 
correct operation of the electronic system. 

Maximum operating distance: 5 metres. The maximum operating distance could be less 
than 5 metres in case of electromagnetic interference by other equipment. 

Light pushbutton on remote control:  light on/off. 

– and + pushbutton: increase/decrease speed (to start the motor press either the + or the 
– pushbutton). 

Timer pushbutton: see instructions below. 

Timer and ‘filter clogged’ alarm pushbutton 

• This function allows the automatic turning off of the hood after running for 15 minutes at 
the speed previously set (the pushbutton shows a flickering light). 

• After about 30 hours of running the pushbutton indicates the need for washing the metal 
filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton 
for a few seconds until the red light turns off. Then turn the hood off and on again to check 
that the alarm has disappeared.