Falmec MERCURIO EVO 60 - Инструкция по эксплуатации - Страница 12

12

 SAFETY INSTRUCTIONS

 AND WARNINGS

Installation operations are to be carried 

out by skilled and qualified installers in ac-

cordance with the instructions in this booklet and 

in compliance with the regulations in force.
DO NOT use the hood if the power supply cable 

or other components are damaged: 

disconnect 

the hood from the electrical power supply and con-

tact the Dealer or an authorised Servicing Dealer for 

repairs.

Do not modify the electrical, mechanical or func-

tional structure of the equipment.
Do not personally try to carry out repairs or re-

placements. Interventions carried out by incompe-

tent and unauthorised persons can cause serious 

damage to the unit or physical and personal harm, 

not covered by the Manufacturer's warranty.

WARNINGS FOR THE INSTALLER

TECHNICAL SAFETY

Before installing the hood, check the integ-

rity and function of each part. Should 

anomalies be noted, do not proceed with installa-

tion and contact the Dealer.

Do NOT install the hood if an aesthetic (or cos-

metic) defect has been detected. Put it back into 

its original package and contact the dealer.
No claim can be made for aesthetic (or cosmetic) 

defects once it has been installed.

During installation, always use personal protective 

equipment (e.g.: Safety shoes) and adopt prudent 

and proper conduct.
The installation kit (screws and plugs) supplied with 

the hood is only to be used on masonry walls: in case 

of installation on walls of a different material, assess 

other installation options keeping in mind the type 

of wall surface and the weight of the hood (indicated 

on page 2).
Keep in mind that installations with different types of 

fastening systems from those supplied, or which are 

not compliant, can cause electrical and mechanical 

seal danger.
Do not install the hood outdoors and do not expose 

it to atmospheric elements (rain, wind, etc.).

ELECTRICAL SAFETY

The electrical system to which the hood is 

to be connected must be in accordance 

with local standards and supplied with earthed 

connection in compliance with safety regulations 

in the country of use. It must also comply with Eu-

ropean standards regarding radio antistatic prop-

erties. 

Before installing the hood, check that the electrical 

mains power supply corresponds with what is report-

ed on the identification plate located inside the hood.

The socket used to connect the installed equipment 

to the electrical power supply must be within reach: 

otherwise, install a mains switch to disconnect the 

hood when required.

Any changes to the electrical system must be carried 

out by a qualified electrician. 

The maximum length of the flue fastening screws 

(supplied by the manufacturer) must be 13 mm. Use 

of non-compliant screws with these instructions can 

lead to danger of an electrical nature.

Do not try to solve the problem yourself in the event 

of equipment malfunction, but contact the Dealer or 

an authorised Servicing Department for repairs.

When installing the hood, disconnect the 

equipment by removing the plug or switch-

ing off the main switch.

FUMES DISCHARGE SAFETY

Do no connect the equipment to discharge 

pipes of fumes produced from combustion 

(for example boilers, fireplaces, etc.).

Before installing the hood, ensure that all standards in 

force regarding discharge of air out of the room have 

been complied with.

Deviation for Australia and New Zeland: Range hoods 

and other cooking fume extractors may adversely 

affect the safe operation of appliances burning gas 

or other fuels (including those in other rooms) due 

to back flow of combustion gases. These gases can 

potentially result in carbon monoxide poisoning. 

After installation of a range hood or other cooking 

fume extractor, the operation of flued gas appliances 

should be tested by a competent person to ensure 

that back flow of combustion gases does not occur. 

(AS/NZS 60335.2.31:2013/A4:2020)