Falmec Kristal 60 ix (800) ECP - Инструкция по эксплуатации - Страница 22

20

at point b.

Square halogen light

3.  FLUORESCENT TUBE

(Section reserved for qualified installers)

Replacing the fluorescent tube:
a)  Disconnect the device from the mains;
b)  Unscrew the fixing screws and remove the bottom panel;
c)  Remove the fluorescent tube, by rotating through 90°, and replace it with 

one of similar features (8W-13W-21W-28W according with the model);

d)  Reconnect the device to the mains.

MAINTENANCE AND CLEANING

L

Constant maintenance ensures the correct operation and efficiency of the ap-
pliance over time. Special attention should be paid to the metal grease-trap-
ping filters and the charcoal filters. Frequent cleaning of the filters and their 
supports will ensure that fats and grease do not accumulate on the range 
hood, with the consequent risk of fire.

1.  METAL GREASE-TRAPPING FILTERS

These trap the fat and grease particles suspended in the air, and therefore 
should be washed every month in hot water and detergent, without bend-
ing them. Wait until they are completely dry before repositioning them. 
To remove and replace these filters, see the instructions in point H1. This 
operation should be performed at regular intervals. 

2.  CHARCOAL FILTERS

These trap the odours present in the stream of air that passes through 
them. The air is purified by passing a number of times through the filters 
and being recirculated into the kitchen. The charcoal filters cannot be 
cleaned, and should be replaced on average every 3-4 months (according 
to use). To replace the charcoal filters, see the instructions in point H2.

3. CLEANING THE OUTSIDE OF THE APPLIANCE

It is advised to clean the external hood surfaces at least every 15 days in 
order to avoid that oily or greasy substances affect the steel surfaces. 

The ouside of the range hhod should be cleaned using a damp cloth and 
neutral liquid detergent or denatured alcohol. 

In case of fingerprint-less finish (fasteel) clean only with water and neutral 
soap using clean with a soft cloth, rinse and wipe dry thoroughly. Do not use 
products that contain abrasive substances, rough cloths or cloths specifically 
designed for cleaning steel. Using abrasive substances or rough cloths will