Falmec Horizon 90 ix (800) - Инструкция по эксплуатации - Страница 33

31

-  Insert the chimney-extension set (G+H) in the motor body (CM). 
-  Fasten the chimney-extension set (G+H) to the extension support elements (SP) or onto the 

top trellis TS with the 4 metric screws M4 (V5) without screwing them all the way. 

(Fig. M1)

-  Lift the hood body so that its lower holes are centred on the 4 M5 metrics screws of the 

motor chamber (CM). Shift the motor chamber (CM) sideways so that the metric screws are 
positioned on the slots and then tighten them permanently.

Phase 3

(Fig. N)

-  Remove the paper tape, unscrew the 4 M4 metric screws (V5) previously screwed onto the 

extension support elements (SP) and slide the chimney-extension set (G+H) downwards.

-  Perform the following connections:
 

EXHAUST -> NRS pipe + elbow (A+B) to exhaust pipe (F). For the filter version (see sec. F) 
the air exhaust must be directed towards the extension slots.

ELECTRIC (only after having disconnected power).

-  Fasten the extension (H) once again to the extension support elements (SP) with the 4 M4 

metric screws (V5).

-  Slide the chimney (G) downwards and fasten it to the hood body with the self-threading 

screws (V6).

-  Reconnect the male connector (CO) to the matching female connector fastened to the hood 

body.

-  Following the indications in sec. H1, reassemble the metal filters and the eventual perime-

ter suction panel (AP). In the case of the Lumina NRS Island hood, reassemble the front 
panel (PN). 

-  Power the hood complying with the regulations in force (see sec. D of the booklet).