Falmec Gruppo Incasso PRO - Инструкция по эксплуатации - Страница 12

12

 USING THE RADIO CONTROL

WARNINGS!:

The radio control is optional.
Follow the entire procedure described below if purchased.

Place the hood away from sources of electromagnetic waves (e.g. microwave ovens), 
which could interfere with the radio control and with the hood electronics.
The maximum operating distance is 5 metres, that may vary according to the pres-
ence of electromagnetic interferences. 
Radio control operated at 433.92MHz.
The radio control consists of two parts:
- the receiver built into the hood;
- the transmitter shown here in the igure.

DESCRIPTION OF TRANSMITTING COM-
MANDS

UP

Motor switch-on and speed increase from 1 
to 4. Speed 4 is only active for a few minutes.

DOWN

Speed decrease and motor switch-of

Light ON-OFF

TIMER ON: 

The motor automatically switch-

es of after 15 min.
The function is automatically disabled if the 

motor is switched of (

 key)

Command transmission active

ACTIVATION PROCEDURE

Before using the radio control, follow the procedure below on the 

hood pushbutton panel

:

•

  Press LIGHT 

 and TIMER 

 simultaneously until all LEDs start lashing. 

•

  Release the two keys and press LIGHT 

 again until all LEDs are lit up. 

•

  Release LIGHT 

: now the receiver is active.

This procedure is also used to deactivate the receiver.

RADIO CONTROL CODE CHANGE

With only one radio control, go directly to point 2.
With several radio controls in the same room, a new code can be created by following the 
procedure below.

Disconnect the power to the hood before starting the procedure.

1) - CREATE A NEW CODE

The procedure is to be carried out on the radio control.

•

  Press LIGHT 

 and TIMER 

 simultaneously until the display starts lashing.

•

  Press DOWN 

 on the radio control: saving is conirmed by three brief lashes of the 

display. The new code cancels and replaces the previous default code. 

Reconnect the hood to the electrical power supply, making sure that the 
lights and motor are of. 

2) - PAIRING THE RADIO CONTROL WITH THE HOOD
        USING THE ELECTRONIC PUSHBUTTON PANEL
 

press TIMER 

on the hood pushbutton panel

 for 2 seconds:

the red LED lights up. 
press any key on the radio control within 10 seconds. 

RESTORING DEFAULT CODE

the procedure is to be carried out if the hood is disposed of, sold or transferred.

Disconnect the power to the hood before starting the procedure.

•

  Press UP 

 and DOWN 

 simultaneously on the radio control for more than 5 sec-

onds: reset is conirmed by three brief lashes of the display. 

•

  Reconnect the hood to the electrical power supply.

•

  Proceed with associating the hood and the radio control, as described in point 2.