Falmec Aura 120 - Инструкция по эксплуатации - Страница 18

16

  Before performing any cleaning or maintenance operations, disconnect the appliance by un-

plugging it or using the main switch. The manufacturer disclaims all liability for any damage 
that may be directly or indirectly caused to people, things and animals due to the failure to 
follow all the instructions provided in this booklet and above all the warnings relating to the 
installation, operation and maintenance of the appliance.

- there is a fire risk if cleaning is not carried out in accordance with the instructions.

CAUTION:

 Accessible parts may become hot when used with cooking appliances.

WARNING:

 Failure to install the screws or fixing device in accordance with   these instructions 

may result in electrical hazards.

Warning only for Australia: hood width less than 90 cm: use max. 4 hobs

CAUTION:

This product must be disposed of at end of life according to the rules in force.

TECHNICAL SPECIFICATIONS

B

The technical data pertaining to the electric appliance The technical specifications of the ap-
pliance are shown on the rating plates located inside the range hood.

INSTALLATION

C

(Section reserved for qualified installers of the range hood)

The recommended distance between the cooker and the lower part of the range hood for the 
installation is about 110 cm. In borderline cases, with a slight efficiency loss, the distance can 
be increased to about 150 cm. The minimum distance cannot be less than 65 cm, as envisioned 
by the Standard.
Should the instructions of the gas cooker specify a greater distance, take this into considera-
tion.
Assembly instructions: see section “M” of the booklet.

ELECTRICAL CONNECTIONS

D

(Section reserved for qualified installers)

WARNING! 
Before doing any work inside the range hood, disconnect the appliance from the mains 
power supply. 
Check that the wires inside the range hood are not disconnected or cut; if this is the case, 
contact your nearest service centre. The electrical connections must be performed by quali-
fied personnel. 

The connections must be performed in compliance with the legal standards in force. Check 
that the relief valve and the electrical system are able to support the load of the appliance (see 
the technical specifications in point B). 
Some types of appliance are supplied with a cable without plug; in this case, “standardised” 
plugs must be used, keeping in mind that: 
- the yellow-green wire must be used for the earth, 
- the blue wire must be used for the neutral, 
- the brown wire must be used for the phase; the cable must not come into contact with hot 

parts (over 70°C). 

- fit a plug that is suitable for the load to the power cable, and connect it to a suitable power 

outlet.