Elica Wave UX BL MAT/F/51 - Инструкция по эксплуатации - Страница 20

20 

Reset coal filter saturation signal (FLASHING ORANGE 
(amber) LED light)  
First proceed with filter maintenance as described in 
corresponding paragraph. 

Press and hold down (for more than 3 seconds) the 

T1 

button 

on the control panel, the LED light will stop flashing indicating 
that the signal reset has been carried out, the hood will switch 
off. 

Coal filter saturation signal disactivaction (for particular 
applications)  

Switch off hood (see above paragraph “suction speed (power) 
selection”).  
Press and hold down (for more than 5 seconds) the 

T1 

button 

on the control panel, the LED light will start flashing GREEN 
indicating that the coal filter saturation signal has been 
disactivated.  
In order to reactivate the coal filter saturation signal, repeat 
operation, the LED light will flash ORANGE (amber)  

Command panel disassembly. 

Remove equipment from electrical grid.  
Remove grease filter.  
Disconnect connectors.  
Extract command panel by lifting it with a small screwdriver or 
similar tool. 

Fig. 22 

Maintenance 

Cleaning

Clean using 

ONLY

 a cloth dampened with neutral liquid 

detergent. 

DO NOT CLEAN WITH TOOLS OR 

INSTRUMENTS

. Do not use abrasive products. 

DO NOT USE 

ALCOHOL! 

Grease filter 

Fig. 21 
Traps cooking grease particles. 

This must be cleaned once a month (or when the filter 
saturation indication system – if envisaged on the model in 
possession – indicates this necessity)  using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle. 
When washed in a dishwasher, the grease filter may discolor 
slightly, but this does not affect its filtering capacity. 

Charcoal filter (filter version only) 

Fig. 21 
It absorbs unpleasant odors caused by cooking. 

The charcoal filter can be washed once every two months (or 
when the filter saturation indication system – if envisaged on 
the model in possession – indicates this necessity)   using hot 
water and a suitable detergent, or in a dishwasher at 65°C (if 
the dishwasher is used, select the full cycle function and leave 
dishes out). 
Eliminate excess water without damaging the filter, then put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 
damaged. 

Replacing lamps 

Disconnect the appliance from the electricity. 

Warning! 

Prior to touching the light bulbs ensure they are 

cooled down. 

To replace the central lamp: 

Replace the damaged lamp. 
Use 5W-GU10 LED lamps only. For more details, check 
enclosed leaflet “ILCOS D” (alfanumeric position “

4b

”). 

Removing the bulb:  

rotate anti-clockwise a quarter turn and take out.   

Mounting the bulb:  

insert the bulb in its seat so that its contacts enter the 
congruent  seats on the bulb-holder, rotate clockwise for about 
a quarter turn. 

Some models envisage lateral lamps: 

Replace the damaged lamp. 
Use E14 2,7W max LED lamps only. For more details, check 
enclosed leaflet “ILCOS D” (alfanumeric position “

1f

”). 

If the lights do not work, make sure that the lamps are fitted 
properly into their housings before you call for technical 
assistance.