Elica Elibloc 9 LX Silver F/80 - Инструкция по эксплуатации - Страница 9

9 

Operation 

The hood is fitted with a control panel with aspiration speed 
selection control and a light switch to control cooking area 
lights. 
The switch is located on the side of the suction grill 

H

. 

Use the high suction speed in cases of concentrated kitchen 
vapours.  It is recommended that the cooker hood suction is 
switched on for 5 minutes prior to cooking and to leave in 
operation during cooking and for another 15 minutes 
approximately after terminating cooking.  

Maintenance 

ATTENTION! 

Before performing any maintenance operation, 

isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend observing these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Grease filter 

Traps cooking grease particles. 

If situated inside the support grill, it may be one of the 
following types:  

Paper filter 

 must be replaced once a month or if colouring 

appears on upper side, in such cases the colouring is evident 
through the grill openings.  

Metallic filter 

must be cleaned once a month, with non 

abrasive detergents,  by hand or in dishwasher on low 
temperature and short cycle.   
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
To access the grease filter 

J

 open the suction grill 

H

 via the 

release hooks 

L

 and free from the supports 

K

. 

Some models are provided with a 

metallic filter M without 

support grill

, these should be washed as described above 

and removed from their housing by pressing the 

N

 handles 

towards the bottom.  

Charcoal filter (filter version only) 

It absorbs unpleasant odours caused by cooking. 

The saturation of the 

charcoal filter

 occurs after more or less 

prolonged use, depending on the type of cooking and the 
regularity of cleaning of the grease filter. 
In any case it is necessary to replace the cartridge at least 
every four mounths. 
The charcoal filter may NOT be washed or regenerated. 
May be one of the following: 

Rectangular: 

position the filter 

P

 in order to cover the motor 

protection grill and turn the handle clockwise until locked-in, 
for dismounting follow instructions in reverse. 

Bayonet Circular-Insert 

position the filter in the centre (in 

certain cases use the 

Z

 hooks for centring the filter) in order to 

cover the motor protection grill ensuring that the X reference 
on the carbon filter corresponds to the 

Y 

reference on the 

conveyor, then turn clockwise; for dismounting follow 
instructions in reverse. 

Replacing lamps 

Disconnect the appliance from the electricity. 

Warning! 

Prior to touching the light bulbs ensure they are 

cooled down. 
Replace the old light bulb with the one of the same type as 
specified in the feature label or near the light lamp on the 
hood. 
Remove the anti-grease filter support grill or the anti-grease 
filter to access the lamp area.  Remove the damaged lightbulb 
and replace with an incandescent oval bulb maximum 

40W 

E14

. 

In the case where model is provided with a halogen lightbulb, 
replace with halogen bulb of 

20W (GU5.3 - Ø50mm)

. 

If the lights do not work, make sure that the lamps are fitted 
properly into their housings before you call for technical 
assistance.