Elica 35CC DYNAMIQUE RED/F/35 - Инструкция по эксплуатации - Страница 62

62 

Operation 

Use the high suction speed in cases of concentrated kitchen 
vapours.  It is recommended that the cooker hood suction is 
switched on for 5 minutes prior to cooking and to leave in 
operation during cooking and for another 15 minutes 
approximately after terminating cooking.  
  
  
The control panel consists of a backlit rotating disk. 
 
 

 
 
 
•To put on and off the lights: 
Press on the disk (T) to put on and off the lights 
 
• To select the available suction speeds: 
Turn the disk (T) clockwise to turn on and increase the suction 
speed and counter-clockwise to decrease it, and to turn off the 
hood. 
The crown (L) lights to indicate the selected suction speed: 
• L1 lit 
speed 1 (minimum). 
• L1 + L2 lit 
speed 2 (medium). 
. • L1 + L2 + L3 lit 
Speed 3 (maximum). 
• L1 + L2 + L3 + L4 lit in flashing mode 
Speed 4 (intensive), lasting for 5 minutes, then the hood is 
placed automatically at speed 2 
• L off: 
Suction motor off 
 

Filters’ Saturation Control 
The hood is equipped with a device that indicates when it is 
required to perform the filter maintenance 
The saturation control device of the grease filter is always 
active 
The control device of the activated carbon filter is usually 
turned off 
To activate it, proceed as follows: 
- Turn off the hood. 
- Press the disk (T) for more than 5 seconds 
The crown (L) lights completely, flashing, and a beep will be 
heard: the control device of the charcoal filter is activated. 
NB = to turn it off, turn off the hood, press the disk (T), L1 + L2 
will be backlit, flashing; wait for the beep to confirm the 
deactivation. 
 
Grease filter saturation indicator 
L1 + L2 flash when you have to perform maintenance of the 
grease filter 
 
Activated charcoal filter saturation indicator 
L3 + L4 flash when you have to perform maintenance of the 
activated charcoal filter 
 
Reset of filter saturation signal 
After filter maintenance, turn on the hood and press the disk 
(T) for more than 5 seconds: you will hear a long tone (beep) 
confirming the reset. 
Note: In case of simultaneous signaling (grease filter and 
activated charcoal filter saturation), you must repeat the reset 
twice. 

Maintenance 

ATTENTION!  Before performing any maintenance operation, 
isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. DO NOT USE ALCOHOL! 
WARNING:  Failure to carry out the basic cleaning 
recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend observing these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations.