De Dietrich DHD 792 X - Инструкция по эксплуатации - Страница 8

36 

Operation 

To select the functions of the hood just touch the commands. 
 

Light key ON/OFF 

Intensive speed selection key

 (suction 

power) - duration 5 minutes - press again to 
return to previous setting. 

High-speed selection key 

(suction power). 

Medium-speed selection key

(suction power) 

- when flashing it indicates the need to wash or 
replace the carbon filter. This signal is normally 
deactivated. Press keys 1 and 2 at the same 
time to activate it. At first only key 1 will flash 
and then both keys 1 and 2 to indicate 
activation. Repeat the operation to deactivate 
the signal. At first keys 1 and 2 will flash and 
then only key 1 to indicate deactivation. 

Low-speed selection key

 (suction power) –

when flashing it indicates the need to wash the 
fats filter. 

Motor key OFF

 (stand by) – excludes the 

electronics – reset wash/replace filters signals. 

MOTOR OFF 

Press briefly to switch the motor off. 

RESET FILTERS SIGNALS

After having carried out maintenance of the 
filters, press the key for 3 seconds. Flashing led 
1 (fats filter) or 2 (carbon filter) will stop 
flashing. 

EXCLUDING THE ELECTRONICS

Press the key for 3 seconds. The hood 
command electronics will be excluded. 
This function can be useful during the product 
cleaning operations. 
Just repeat the operation to reinsert the 
electronics.  

 
If the hood fails to operate correctly, briefly disconnect it from 
the mains power supply for almost 5 sec. by pulling out the 
plug. Then plug it in again and try once more before 
contacting the Technical Assistance Service. 

Maintenance 

ATTENTION! 

Before performing any maintenance operation, 

isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

Warning: 

Failure to carry out the basic cleaning recommendations of the 
cooker hood and replacement of the filters may cause fire 
risks.  
Therefore, we recommend oserving these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Maintenance of the panel 

Dismantling: 

Extract with decision (LOWER SIDE) and rotate upwards. 

Cleaning: 

the panel should be cleaned with the same frequency as 
the fat filters, using a cloth soaked in neutral liquid 
detergents. 
Avoid the use of products containing abrasives. DO NOT 
USE ALCOHOL!  

Montage: 

Proceed in the reverse direction for dismantling.   

Attention! 

Always check that the panel is fixed in its 

place well. 

Grease filter 

Fig. 2 

This must be cleaned once a month (or when the filter 
saturation indication system – if envisaged on the model in 
possession – indicates this necessity)  using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle. 
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
To remove the grease filter, pull the spring release handle. 

Charcoal filter (filter version only) 

Fig. 3 

It absorbs unpleasant odours caused by cooking. 
The charcoal filter can be washed once every two months (or 
when the filter saturation indication system – if envisaged on 
the model in possession – indicates this necessity)   using hot 
water and a suitable detergent, or in a dishwasher at 65°C (if 
the dishwasher is used, select the full cycle function and leave 
dishes out). 
Eliminate excess water without damaging the filter, then put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 
damaged. 
• 

Montage 

Open the steam screen and remove the grease filter.  

Install the carbon filter on the back of the grease filter and