AEG DL6250-ML - Инструкция по эксплуатации - Страница 11

11 

3. 

Install the cover supplied on the opening of the control 
unit. 

4. 

Make a 104 x 25 mm slot for the housing of the control 
panel and fix it in the new seat. 

Operation 

The hood is fitted with a control panel with aspiration speed 
selection control and a light switch to control cooking area 
lights. 
Use the high suction speed in cases of concentrated kitchen 
vapours.  It is recommended that the cooker hood suction is 
switched on for 5 minutes prior to cooking and to leave in 
operation during cooking and for another 15 minutes 
approximately after terminating cooking.  

Maintenance 
ATTENTION! 

Before performing any maintenance operation, 

isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 
The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend oserving these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Grease filter 
Fig. 1-13 
The grease filter

 must be cleaned once a month using non 

aggressive detergents, either by hand or in the dishwasher, 
which must be set to a low temperature and a short cycle.  
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 

Charcoal filter (filter version only) 
Fig. 11 

Type 150 LONG LIFE - Washable activated charcoal filter 

The charcoal filter can be washed once every two months 
using hot water and a suitable detergent, or in a dishwasher at 
65°C (if the dishwasher is used, select the full cycle function 
and leave dishes out). 
Eliminate excess water without damaging the filter, then 
remove the mattress located inside the plastic frame and put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 
damaged. 

Type 150 - NON-washable activated charcoal filter 

The saturation of the activated charcoal occurs after more or 
less prolonged use, depending on the type of cooking and the 
regularity of cleaning of the grease filter. 
In any case it is necessary to replace the cartridge at least 
every four mounths. 
The carbon filter may NOT be washed or regenerated. 

Replacing lamps 

Fig. 14 

Disconnect the hood from the electricity. 

Warning! 

Prior to touching the light bulbs ensure they are 

cooled down. 
Replace the damaged lamp using 11W PL lamps only (G23).