AEG DCE5980HM - Инструкция по эксплуатации - Страница 6

6

www.aeg.com

4. CONTROLS

Button Function

Led

L

Turns the lights on/off at maximum strength.

-

Press and hold the button for approximately 2 seconds to turn the Courtesy 

Lights On/Off.

-

T1

Turns the motor on/off at speed one.

-

T2

Turns the Motor on at speed two.

-

Press and hold the button for approximately 5 seconds, with all the loads 

turned off (Motor and Lights), to turn the Activated Charcoal Filter alarm on. 

The  relevant  LED  flashes  twice  to  confirm.

To turn the alarm off, press the button again and hold for at least 5 seconds. 

The  relevant  LED  flashes  once.

Flashing.

T3

Turns the Motor on at speed three.

-

Press and hold the button for approximately 3 seconds, with all the loads turned 

off (Motor and Lights), to perform a reset. The LED 

S1

  flashes  three  times.

Flashing.

T4

Turns the Motor on at 

INTENSIVE

 Speed.

This speed is timed to run for 6 minutes. At the end of this time, the system 

returns automatically to the speed that was set before. If it is activated with the 

motor turned off, the hood will switch to OFF at the end of the time.

-

Press and hold for 5 seconds to enable the remote control, indicated by the 

LED  flashing  twice.

Press and hold for 5 seconds to disable the remote control, indicated by the 

LED  flashing  just  once.

Flashing.

S1

Signals the Metal Grease Filter saturation alarm, indicating that it is necessary 

to wash the filters. The alarm is triggered after the Hood has been in operation 

for 100 working hours.

Fixed.

When this is activated, it signals the Activated Charcoal Filter saturation alarm, 

indicating  that  the  filter  must  be  changed;  the  Metal  Grease  Filters  must  also 

be washed. The Activated Charcoal Filter saturation alarm comes into operation 

after the Hood has been working for 200 hours.

Flashing.