AEG DCE5980HM - Инструкция по эксплуатации - Страница 3

3

ENGLISH

1. RECOMMENDATIONS AND SUGGESTIONS

• The Instructions for Use apply to several versions of 

this  appliance.  Accordingly,  you  may  find  descriptions 

of  individual  features  that  do  not  apply  to  your  specific 

appliance.

• The manufacturer will not be held liable for any damages 

resulting from incorrect or improper installation.

• The minimum safety distance between the cooker top 

and the extractor hood is 650 mm (some models can be 

installed at a lower height, please refer to the paragraphs 

on working dimensions and installation).

• Check that the mains voltage corresponds to that indi-

cated  on  the  rating  plate  fixed  to  the  inside  of  the  hood.

• For Class I appliances, check that the domestic power 

supply guarantees adequate earthing. Connect the ex-

tractor  to  the  exhaust  flue  through  a  pipe  of  minimum 

diameter 120 mm. The route of the flue must be as short 

as possible.

• Do not connect the extractor hood to exhaust ducts car-

rying  combustion  fumes  (boilers,  fireplaces,  etc.).

• If the extractor is used in conjunction with non-electrical 

appliances  (e.g.  gas  burning  appliances),  a  sufficient 

degree of aeration must be guaranteed in the room 

in  order  to  prevent  the  backflow  of  exhaust  gas.  The 

kitchen must have an opening communicating directly 

with the open air in order to guarantee the entry of clean 

air. When the cooker hood is used in conjunction with 

appliances supplied with energy other than electric, the 

negative pressure in the room must not exceed 0,04 

mbar to prevent fumes being drawn back into the room 

by the cooker hood.

• In the event of damage to the power cable, it must be 

replaced by the manufacturer or by the technical service 

department, in order to prevent any risks.

• If the instructions for installation for the gas hob specify 

a  greater  distance  specified  above,  this  has  to  be  taken 

into account. Regulations concerning the discharge of air 

have  to  be  fulfilled.

• Use only screws and small parts in support of the hood.