Timberk SWH RS1 50 VH - Инструкция по эксплуатации - Страница 11

www.timberk.com • electrical storage water heater

11

7. Bear in mind to check serviceability of the relief valve every 14 days – 

inspection method:

–

 turn the discharge lever to the left up until you feel the change of thread, 

then water must start flowing from the valve’s hole. After checking the 

water flow, return the lever to its initial position.

8. If necessary, wipe external surfaces of the heater by a damp cloth with 

soap.

IMPORTANT! 

If water doesn’t flow, then the valve is damaged. 

In this case you must not use the heater and it is 

recommended to call for a service technician.

Possible malfunctions and troubleshooting methods
Table 4

11. TROUBLESHOOTING

Failure

Possible causes

Troubleshooting method

Heating indicator light doesn’t light up, 
water is not heated

1. Temperature adjustment device 
is broken.

Contact a repairer, TIMBERK service 
center.

2. Temperature limiter was actuated or 
was not switched on.

Switch on the temperature switch 
following instructions on its activation. 
(page 15)

3. Temperature limiter is broken.

Contact a repairer, TIMBERK service 
center.

Water doesn’t flow from the hot water 
discharge cock

1. Water feed is cut off.

1. Wait until water supply is restored.

2. Water pressure is too low.

2. Switch on the water heater again, 
when normal water pressure restores.

3. Water supply exhaust valve is 
closed.

Water temperature is too high

Water temperature control system 
is damaged.

Contact a repairer, TIMBERK service 
center.

Water leakage

Seal at the point of pipe connection 
is broken.

Replace the joint seal.

Water flows from the appliance’s case

Breaking of the internal tank 
(corrosion)Seal at the point of the 
heating element connection is broken.

Contact a repairer, TIMBERK service 
center.

Heating indicator light lights up but 
water is not heated

1. Temperature adjustment device 
is broken.

1. Contact a repairer, TIMBERK 
service center.

2. Insufficient time for heating.

2. Wait until water is heated.

3. Heating element is broken.

3. Contact a repairer, TIMBERK 
service center.