PHILIPS AWH1611/51(50YA) - Инструкция по эксплуатации - Страница 16

14

лампочка - индика

тор работы УЗО (1)

кнопка TEST (2) 

кнопка перезапуска (3) 

отверстие сброса давления

винт

ручка слива

fig  

7

1.   Never drain water if its temperature is 

above 50 °C, as this may cause burns.

2. 

If water does not flow, the valve is

damaged. In this case, the water heater 

must not be used and it is recommended 

tocallaservicetechnician.

Service

1    Check the electrical plug and socket 

as often as possible  Reliable electrical 

contact must be ensured, as well as 

proper grounding  The plug and socket 

must not become excessively hot 

2    If the water heater is not used for a long 

time, especially in regions with low air 

temperature (below 0 °C), to prevent 

damage to the water heater (due to freezing 

of water in the internal tank), the water from 

the heater should be drained 

3    To ensure reliable operation of the water 

heater for a long time and maintain 

warranty obligations, it is recommended 

that regular maintenance by specialists 

of authorized service centers is 

recommended, during which the internal 

tank is cleaned, salt deposits are removed 

from the electrical heating elements of 

the water heater, and the condition of 

the magnesium anode is checked, in case 

consumption of half or more is replaced  

The frequency of maintenance of the 

water heater depends on the hardness of 

the water in the area  Possible intervals 

from 3 months to a year  

The frequency of cleaning the tank depends 

on the hardness of the water  Cleaning must 

be carried out by authorized service centers  

In the warranty card, a note is required that 

maintenance is carried out at least once 

every 12 months 
4    Preventive work must be carried out 

with strict observance of the operating 

instructions and safety precautions by 

specialists of authorized service centers 

5    In case of water overheating, the thermal 

biopolar fuse breaks the electrical circuit on 

both sides of the heating element  In this 

case, determine the cause of overheating 

and reset the thermostat manually by 

pressing the reset button located on the 

thermostat (or, in case of a malfunction, 

replace the thermostat) 

6    Remember to check the operation of the 

safety valve every 14 days  Check method:

  –  move the drain handle to the upper 

position until you feel the transition of 

the thread, and then water should flow 

from the valve hole 

After  checking  the  water  flow,  return  the 

handle to the previous position 
7    Check periodically for scale and blockage  

Drainage of the valve, in order to avoid 

clogging, is carried out as follows: if the 

valve has a lever, then it must be lifted 

several times, if the valve is without a 

lever, it must be unscrewed and scale 

accumulations removed 

Attention!

pressure relief hole

screw

drain handle