Водонагреватели Gorenje GBFU100EB6 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
18
EN
The rotating knob on the control panel may be set to various positions:
Knob position Setting
Appliance switched off
Protection against freezing, temperature regulation set to 10ºC
Setting and regulation of temperature to 35ºC
Optimum setting, temperature regulation set to 55ºC
Maximum setting, temperature regulation set to 75ºC
The signal lamp indicates the status of the heating element and anti-corrosion Magnesium
anode (Mg anode). The anti-corrosion protection may fail due to worn out of Mg anode or
bad connection to Mg anode.
Signal lamp status
Indication
Green
Heating element switched on, Mg anode active
Orange
Heating element switched on, Mg anode not active
Red
Heating element switched off, Mg anode not active
Lamp off
Heating element switched off, Mg anode active
Red - flashing
Heating element not operating, sensor disconnected
Warning!
When the water heater is out of use for longer period of time, the signal lamp may
indicate that the Mg anode is worn out in spite of the fact that the Mg anode is still active.
In this case open the hot water tap (fresh water flow into water heater). If the signal lamp
switches off, the water heater operation is not impaired. If not, call the nearest authorized
service provider.
Temperature indication:
Bimetal thermometer is installed on the water heater housing. When the water in the water
heater is heated, the thermometer pointer rotates clockwise.
Freezing protection:
When the water heater is not in use for longer periods of time, it should be protected from
freezing by setting the temperature to
. Do not disconnect the power. Thus the temperature
of water is maintained at about 10°C. Should you choose to disconnect the power, the water
heater should be thoroughly drained before the onset of freezing conditions.
Discharging water from the water heater:
Water is discharged from heater via the inlet pipe. To this purpose, a special fitting (T-fitting)
must be mounted between the relief valve and the heater inlet pipe, or a discharge tap.
The heater can be discharged directly through the relief valve, by rotating the handle or the
rotating valve cap to same position as for checking the operation. Before discharge, make
sure the heater is disconnected from the power supply, open the hot water on the connected
