Smeg CVI338X - Инструкция по эксплуатации - Страница 11

Use

37

EN

Alarms

Each alarm consists of a message flashing 

on the display, the alarm key 

lighting

up and an audible warning.
The display continues to flash until the alarm 
condition finishes.
•  

To deactivate the alarm, press the 

alarm button

.

Temperature alarm

The temperature on the display may start to 
flash. This means that the temperature inside 
the wine cellar compartment is too high or 
too low in relation to that set.
This may occur:
•  when the appliance is first turned on;
•  if a temperature much higher or much 

lower than the previous one is set;

•  if the wine cellar is loaded with many 

bottles at ambient temperature; 

•  in the event of an extended interruption in 

mains voltage.

These conditions may occur during normal 
operations of the appliance and are not 
caused by problems/faults.
In this case, deactivate the alarm with the 
alarm button 

 and wait for the 

temperature to return within the normal 
storage values. It may be necessary to 
repeat this operation 1–2 times.

Other alarm types

The message 

 will appear on the 

display on the left. 

The door has been left 

open for more than 60 seconds.

•  Close the door.

Messages  

to  

(excluding ) 

or 

else 

 or 

 appear on the display on 

the left: 

Appliance fault

•  Switch off the appliance and call 

Technical Support.

Control lock

To activate the control lock:

•  Press and hold the Control lock key 

for at least 3 seconds.

To deactivate the control lock:

•  Press and hold the Control lock key 

for at least 3 seconds.

The alarms help protect the wine 
from temperatures which could 
compromise its quality.

If the alarm continues to occur, call 
Technical Support.

The alarm will reactivate in the 
same way 60 seconds after it is 
shut off if the door is still open.

This function prevents the 
appliance from being accidentally 
switched off. When active, the 
control panel will not react when 
any key is pressed.