Liebherr WKes 4177 - Инструкция по эксплуатации - Страница 4

18

Setting up

• Avoid locating it in direct sunlight or near heat sources such as an oven or a radiator.
• The floor should be level and even.  You can compensate for an uneven floor by ad-

justing the adjustable feet. 

• Please make sure the appliance is properly ventilated. 
• Standard EN 378 specifies that the room in which you install your appliance must 

have a volume of 1 m

3

 per 8 g of R 600a refrigerant used in the appliance, so as to 

avoid the formation of inflammable gas/air mixtures in the room where the appliance 
is located in the event of a leak in the refrigerant circuit.  The quantity of refrigerant 
used in your appliance is indicated on the type plate on the inside of the appliance.

• The appliance is set to operate within specific ambient temperature limits according 

to its climate rating. These temperature limits should not be exceeded. The correct 
climate rating for your appliance is indicated on the type plate. 

  SN - ST = +10°C to +38°C
  SN - T = +8°C to +43°C

Dimensions

WK 2977: height: 1264 mm, width: 660 mm, depth: 671 mm 
WK 4177: height: 1658 mm, width: 660 mm, depth: 671 mm
WK 4677: height: 1855 mm, width: 660 mm, depth: 671 mm

Electrical requirement

Power supply (AC) and voltage at the operating point must comply with the details on 
the type plate. The type plate is located on the top left-hand side on the inside of the 
appliance. The socket must be fused with a 10 A fuse or higher, it must be away from 
the rear of the appliance and must be easily accessible.

Operating and control elements



 Temperature display



 Temperature setting buttons



 Audible warning on/off button



 Interior light on/off button



 Child-proof lock



 On/off button



 Fan switch