Drive 550 - Инструкция по эксплуатации - Страница 25

25

EN

USING THE DEVICE

INSTALLING

•  It is the best to mount the dash camera in the upper edge of the car’s front windshield, 

beneath the rear-view mirror or next to it.

•  Clean the mounting area carefully and ensure the windshield is not damp.

•  Ensure there is unobstructed view to the camera and that the vision of the driver is not 

blocked.

•  Ensure that the selected mounting area is suitable for the length of the USB charging 

cable

•  Remove the protective film of the fastening tape of the camera holder and fasten the 

holder by pressing it firmly on the windshield

•  Insert an empty micro SD card in the dedicated slot.

•  Connect the camera carefully to the magnetic connector of the camera holder and 

connect the USB charging cable. The USB charging cable is long enough so that in most 

passenger cars it can be mounted along the edge of the windshield to the charging 

socket.

•  The camera switches on automatically when the power is turned on.

PLEASE NOTE!

•  The device is fastened with a very strong acrylic foam tape, which resists changing 

conditions and UV radiation. It is not recommended to remove it and to re-fasten 

it.However, if it is necessary to remove the camera holder and to re-fasten it, a new tape 

strip should be used.

•  The easiest way to remove the camera holder is to remove first the camera and thereat 

to grasp firmly from the edges from the edges of the holder, as close as possible to the 

windshield.by turning the holder clockwise or anti-clockwise, the tape should release.As 

the tape is characterised by strong tensile strength, it is difficult to remove it by pulling. 

Do not use a screwdriver or any other tool for removing ,as this may damage the holder or 

windshield.

•  In some car models power supply to the charging socket is not interrupted when the 

engine is switched off. In this case disconnect the charger from the charging socket, to 

avoid draining the car’s battery.