Zigmund Shtain GN 17.451 A - Инструкция по эксплуатации - Страница 25

002 LINGUE  28-09-2005 19:29  Pagina 25

Instructions for use

The hob control area houses the devices and knobs for operation of the gas

burners.

In order to ignite a burner, it is necessary to depress the knob while rotating it anti-

clockwise, till the index is aligned with the position corresponding to the maximum

gas delivery (i.e. the large flame symbol). As far as the

models equipped with a safety valve are concerned,

once the flame is lit hold the knob depressed for about

3-4 seconds, till the device keeps the burner automati-

cally lit. At this moment it is possible to adjust the flame

intensity by rotating the knob anticlockwise from such

maximum position to the minimum one (i.e. the small

flame symbol).

In order to turn the burner off, rotate the knob clockwise bringing the index back to

the position corresponding to the closure symbol       .

RECOMMENDATIONS

In case of electric power failure, it is necessary to carry out the above-described

operations by putting a gas lighter or a flame near the burner (in such an event, pay

the utmost attention not to burn yourself).

The safety valve (for models where such item is provided) intervenes in case of acci-

dental flame failure, blocking the gas delivery (e.g.: air draughts, spillage of liquids,

etc.).

In any case, the ignition device must not be actuated for longer than 15 seconds.

Should the ignition manoeuvre fail, or should the burner be accidentally turned off,

immediately close the actuation knob and repeat the ignition after one minute at

least.

Once the ignition has taken place, adjust the flame according to your needs.

Operation of gas burners

6 - ENGLISH