Gaggenau CK 260-104 - Инструкция по эксплуатации - Страница 10

9

6.1 Technical data

Appliance dimensions: L 580 x T 510 x H 63,5 mm
Installation dimensions: L 560 x T x 490 x H 55 mm
Total rating: 6.0 kW

6.2 Important notes on installation

– Pay attention to the 

"Important notes"

(Chapter 1).

– The appliance must only be connected by an 

authorised specialist

, paying attention to 

the relevant regulations of the power supply 
companies and the regional construction 
regulations. 

– The 

electrician 

is responsible for the correct 

functioning of the appliance at the time of 
installation. He must instruct the user on how to 
operate the appliance correctly on the basis of 
the Operating Instructions, and the user must be 
instructed on how to disconnect the appliance 
in an emergency.

–  If the range is not installed over a built-in cooker, 

protection against hazardous contact

from 

below must be ensured after assembly, e.g. by 
installing an intermediate shelf that can only be 
detached using a tool.
The distance between the intermediate shelf and 
the worktop in which the range is recessed must 
be 

at least 60 mm.

– 

Note:

when installing a shelf, observe a distance 

of at least 50 mm from the bottom edge of the 
housing trough to the shelf or the next 
combustible item of furnishing.

–  If all poles of the appliances cannot be isolated 

from the mains by removing an accessible plug 
(of a permanent connecting lead), an isolating 
device with a contact gap of 

at least 3 mm

must 

be installed (e.g. domestic fuse).

– 

No warranty claims can be lodged for any 
damage resulting from failure to observe 
these instructions.

–  When the appliance is 

installed

in a base cabinet 

with a width of less than 60 cm, the housing can 
lie on the side walls of the cabinet. These cabinet

side panels must be modified so that the 
appliance is not in contact with them.

– 

Note:

Please note that a distance of 10 mm from 

the base cabinet must be observed for safety 
reasons.

–  The distance from the lower edge of the housing

trough to the next combustible item of furnishing 
at the side should be 

at least 20 mm.

– 

Note: 

Do not stick the cooking surface onto the 

worktop with silicone !

Electrical connection:

–  Rated power consumption: 6.0 kW
– The appliance must only be connected by an 

authorised specialist.

– All corresponding regulations must be observed.
–  The mains connecting cable must at least 

correspond to the type H 05 VV-F.

– 

Pay attention

to the data on the rating plate 

and connect the PE conductor. Connect the 
connecting cable to the mains. The appliance can 
be connected with a plug or it can be connected 
permanently.

– 

When connecting

electrical appliances and 

devices in the proximity of cooking surfaces and 
ovens, make sure that connecting cables do not 
become jammed under the hot oven door or 
come into contact with hot cooking surfaces.

– This cooker corresponds to 

heat class Y

and 

must be installed in a cabinet as detailed in the 
sketch (Fig. 7). 

–  This appliance may be installed in kitchen

combinations made of wood or similar combustible
materials without taking additional measures.

6. Assembly instructions

CK 260-504

FD xxxx

AC 240 V 

50 Hz

6000 W 

25 A

CK 260-104

FD xxxx

AC 230/400 V

3 N / 50/60 Hz

6000 W 

3 x 16 A