Fulgor Milano FCH 604 G BK - Инструкция по эксплуатации - Страница 12

12

GB

Installation

All the operations concerned with the installation 
(electrical and gas connections, adaptation to type of 
gas, necessary adjustments, etc.) must be carried out 
by qualified technicians, in terms with the standards 
in force. For specific instructions, kindly read the part 
reserved for the installation technician.

Use

Use Gas burners (Fig. 1-3)

The ignition of the gas burner is carried out by putting 
a small flame to the upper part holes of the burner, 
pressing and rotating the corresponding knob in an 
anti-clockwise manner, until the maximum position has 
coincided with the marker. When the gas burner has 
been turned on, adjust the flame according to need. 
The minimum position is found at the end of the anti-
clockwise rotation direction. 
For models with automatic/ simultaneous (with one 
hand) ignition, it is sufficient to proceed as described 
above using the corresponding knob. The electric spark 
between the ignition plug and the burner provides the 
ignition of the burner itself. After ignition, immediately 
release the push-button and adjust the flame according 
to need. For models with a thermoelectric safety system, 
the burner is ignited as in the various cases described 
above, keeping the knob fully pressed on the maximum 
position for approximately 3/5 seconds. After releasing 
the knob, make sure the burner is actually lit. 
N.B.

- We recommend the use of pots and pans with a 

diameter matching that of the burner, thus preventing 
the flame from escaping from the bottom part and 
surrounding the pot;

-  do not leave any empty pots or pans on the fire;
-  do not use any tools for grill-cooking on Crystal hobs. 

When cooking is finished, it is also a good norm to close 
the main gas pipe tap and/or cylinder. 

DWK models
Models SH 775 G DWK, SH 905 G DWK and SH 1124 
G 2DWK have a Dual Wok burner. The centre flame (F1) 
can be lit by pressing the knob and turning it clockwise 
or the entire burner (F2) can be lit as shown in the figure 
below.

Important

GAS PROTEKT

On floors with thermoelectric protection (Gas Protekt) 
do not keep the ignite button pushed for more than 15 
seconds. If the burner has not ignited after 15 seconds, 
open the door of the room and wait at least one minute 
before making a further attempt.

wok 

Ø 20-32

fast 

Ø 20-26

semifast 

Ø 14-20

auxiliary* 

Ø 10-14

*with reduction grid

GAS

Fig. 1

Instructions for use

F1

F2

F1

F2

F1

F2

F1

F2