Fulgor Milano CPH 401 GDWK X - Инструкция по эксплуатации - Страница 12

12

13

GB

Installation

All the operations concerned with the installation 
(electrical and gas connections, adaptation to type of 
gas, necessary adjustments, etc.) must be carried out 
by qualified technicians, in terms with the standards 
in force. For specific instructions, kindly read the part 
reserved for the installation technician.

Use

Gas burners

The ignition of the gas burner is carried out by putting 
a small flame to the upper part holes of the burner, 
pressing and rotating the corresponding knob in an 
anti-clockwise manner, until the maximum position has 
coincided with the marker. When the gas burner has 
been turned on, adjust the flame according to need. The
minimum position is found at the end of the anticlockwise
rotation direction. In models with automatic ignition, 
operate the knob as described above, pressing 
simultaneously, the corresponding push-button. For 
models with automatic/ simultaneous (with one hand) 
ignition, it is sufficient to proceed as described above 
using the corresponding knob. The electric spark 
between the ignition plug and the burner provides the 
ignition of the burner itself. After ignition, immediately 
release the push-button and adjust the flame according
to need. For models with a thermoelectric safety system, 
the burner is ignited as in the various cases described 
above, keeping the knob fully pressed on the maximum 
position for approximately 3/5 seconds. After releasing 
the knob, make sure the burner is actually lit.

Models with Dual Wok burner

Some models have a Dual Wok burner. The centre 
flame (F1) can be lit by pressing the knob and turning it 
clockwise or the entire burner (F2) can be lit as shown 
in the figure below.

F1

F2

N.B

- We recommend the use of pots and pans with a 

diameter matching that of the burner, thus preventing 
the flame from escaping from the bottom part and 
surrounding the pot (Fig. 1);

-  do not leave any empty pots or pans on the fire;

When cooking is finished, it is also a good norm to close 
the main gas pipe tap and/or cylinder. 

dual 

Ø 20-32

fast 

Ø 20-24

auxiliary* 

Ø 10-14

GAS

Fig. 1

Important

•  Use of the appliance produces heat and moisture in 

the room where it is installed. Make sure the kitchen 
is sufficiently ventilated; keep natural ventilation holes 
open or install mechanical ventilation devices (such 
as a hood).

•  Prolonged use of the appliance may require additional 

ventilation, such as opening a window.

• On floors with thermoelectricprotection do not keep 

the ignite button pushed for more than 15 seconds. If 
the burner has not ignited after 15 seconds, open the 
door of the room and wait at least one minute before 
making a further attempt.

•  On floors without protection, should the burner flame 

go out close the corresponding gas cock and wait at 
least one minute before making any attempt to ignite 
it.

Instructions for use