Fulgor Milano CH 904 ID TS BK - Инструкция по эксплуатации - Страница 51

50

51

GB

Error code

description

Possible causes

Error recovery

C

The cooking zone can 
be configured if a static 
“C” is shown.

It’s not an error, the user 
is in the serivice menu.

A suitably pan must be 
placed on the relevant 
cooking zone.

C/-

The cooking zone will be 
configured if a blinking 
“C” is shown. After a 
successful configuration 
the relevant display 
shows “-”.
When the “-” is not 
displayed please check 
the possible causes of 
the E/5.

The user is in the 
service menue, it’s not 
an error.

Wait for the sysmbol 
“-” or abort the 
configuratuib activities 
by pressing the 
selectkey and the “C” 
does not blink anymore.

2. over voltage.

Exchange the module.

E/7

Non assignable faillure.

Exchange modul or User 
Interface.

E/8

Fan faillure.

Fan or control electronic 
is defect.

Exchange the modul.

E/9

Defect T sensor on 
inductor.

Sensor signal out of 
valid range; sensor or 
electronic is defect.

Exchange the modul.

E/A

Hardware defect of 
induction modul.

Defect hardware device 
detected by the self 
check of the modul.

Exchange the modul.

E/C

Configuration failure.

2 cooking zone are 
dedicated to the same 
element of the UI.

1. Erase the actual 
configuration manual 
with service menù.

E/H

Fixed sensor value (test 
function for T sensor on 
inductor).

Not enough temperature 
change (10K) within 5 
min after switch on the 
hob.

Systerm must cool 
down.

No functionality 
and no displaying

Overvoltage on the 
switch mode power 
supply (jno fuctionality).

400V connection.

Disconnet and 
correct the power line 
connection.

E

A blinking “E” on each 
cooking zone indicates, 
that all configs will be.

The user is in the 
service menù, it’s not an 
error.

Manual configuration.

E/2
(Error code 
different for some 
UI)

Temperature limits are 
excessed.

1. Pot or glas 
temperature is to
2. NTC - electronik 
temperature to high.

System must cool down.