Bertazzoni PM60 3 0 X - Инструкция по эксплуатации - Страница 6

6

3) Beside the tap bar on the work top, use a small screwdriver that fits the screw (gold) found on the lower 
part of the tap and turn the fixing screw to the right or left until the flame of the burner is regulated in the most 
suitable way to MINIMUM. 
4) Make sure that that the flame does not go out when changing the position quickly from MAXIMUM to the 
MINIMUM position.  

ATTENTION: The regulation described above can be carried out only with burners using natural gas, 
while with burners using propane gas the screw must be fully screwed in, in a clockwise direction.   

Descriptions 

DESCRIPTIVE CAPTION FOR HOB 

DESCRIPTION OF HOBS 

1. Dual burner   

Model 

‘A’

 Fig. 11 

2. Rapid burner 

Model 

‘B’ 

Fig. 12 

3. Medium burner 
4. Small Burner 

5. Dual in burner control knob 

6. Dual out burner control knob 
7. Rapid burner control knob  
8. Medium burner control knob 
9. Small burner control knob 

Service & maintenance instructions 

Service and maintenance only to be carried out by an authorised person 

To replace parts such as burners, valves and electric components, the hotplate must be removed from the 
bench top by releasing the attachment hooks, loosening the attachment screws of each burner, unscrewing 
the hotplate attachments nuts which are visible at the bottom of the surface, removing the hotplate top and 
finally replacing the defective parts. 

Note:

 if the valves must be replaced, first disassemble the ignitions switches wires. 

It is recommended to replace the valve gaskets each time the valve is replaced, thus ensuring a perfect seal 
between the body and the gas train. 

WARNING: Disconnect power before servicing unit. 

For the location of the wall receptable for the connection of the three-pin earthed plug of the 
appliance, see indications given in Fig. 1- 2  

WARNING: After first installation of the appliance or after any service intervention concerning main 
gas parts of the appliance, make the leak test using water with soap on the gas connections in order 
to verify the correct installation. Do not use fire for gas leak testing. 

User instructions 

WARNINGS:

Keeping appliance area clear and free from combustible materials, gasoline and other flammable 
vapors and liquid. 

Do not store dangerous or flammable material in the cabinet areas above appliance; store them in a 
safe place in order to avoid potential hazards. 

For safe use of appliance, do not use it for space heating.  
Do not use aerosol sprays in the vicinity of this appliance while it is in operation 

For description of hotplates refer to installation instructions. 

Using burners

A diagram is etched on the control panel above each knob which indicates which burner corresponds to that 
knob. 

Manual ignition:

Manual ignition is always possible even when the power is cut off or in the event of prolonged power failure. 
Turn the knob that corresponds to the burner selected counterclockwise to the MAXIMUM position at the 
etched star (large flame) and place a lit match up to the burner. 

Burners fitted with a safety device (thermocouple):