Kuppersberg FV6TGRZ W - Инструкция по эксплуатации - Страница 33

33

ENGLISH

TECHNICAL PASSPORT

Gas hob

1.  Left burner control switch

2.  Middle front burner control switch

3.  Middle rear burner control switch

4.  Right rear burner control switch

5.  Right front burner control switch

7.2.  B A S I C  S E T T I N G S 

7.2.1. FOR GAS BURNERS 

Operation of the burners and power 

levels Turn the control switch left-wise 

until reaching to maximum level. When 

you press the control switch all burning 

igniters will have flame to burn. Release 

the switch in few seconds after burning 

of the burner, and bring the control 

switch  to  the  desired  flame  position 

between the maximum and minimum 

levels.

If the flame is gone when you release 

the switch You should repeat the above 

process. But this time press the switch 

and hold for about 10 seconds.

WARNING: Do not use burning 

system more than 15 seconds. If the 

burner will not be burned within such 

time  or  if  the  flame  will  be  cut  for  any 

reason whatsoever, repeat burning 

process after waiting for 1 minute.

Closing the burners

Turn the control switch right-wise to 

close the hob.

Flame Failure Device (FFD)

All burners on your hob are 

equipped with Flame Failure Device 

system against flame extinguishing risk 

(water  flow,  wind  etc.)  When  the  flame 

was gone while the burner switch is 

open such system will prevent cutting 

of the gas supplied to the burner. If the 

burning of the burner will be cut due 

to safety, repeat the burning operation 

by switching the burner switch to off 

position.

Fig. 8

Using Right Burner 

Â

The pan diameter and the 

burner power should match in order to 

efficiently  use  it. The  diameters  proper 

for each burner are given in the table. 

Â

Select the proper pan diameter 

and  volume  in  order  to  define  the 

proper burner.