VITEK VT-2335 BK - Инструкция по эксплуатации - Страница 4

Увлажнители VITEK VT-2335 BK - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.

Если остались вопросы, задайте их в комментариях после инструкции.

"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Страница:
/ 28
Загружаем инструкцию
background image

4

 ENGLISH

a person who is responsible for their safety or 
if they are not instructed by this person on the 
usage of the unit. 

 •

Do  not  leave  children  unattended  to  prevent 
using the unit as a toy.

 •

For children safety reasons do not leave poly-
ethylene  bags,  used  as  packaging,  unat-
tended.

Attention!  Do  not  allow  children  to  play  with 
polyethylene bags or packaging film. Danger of 
suffocation!

 •

Never  pull  the  power  cord  when  disconnect-
ing  the  unit  from  the  mains;  take  the  power 
plug  and  carefully  pull  it  out  of  the  mains 
socket.

 •

Never  use  the  unit  if  the  power  cord  or  the 
power  plug  is  damaged,  if  the  unit  works 
improperly or after it was dropped.

 •

Do not attempt to repair the unit. Do not disas-
semble the unit by yourself, if any malfunction 
is  detected  or  after  it  was  dropped,  unplug 
the  unit  and  apply  to  any  authorized  service 
center  from  the  contact  address  list  given  in 
the  warranty  certificate  and  on  the  website 
www.vitek.ru. 

 •

Transport the unit in the original package only.

 •

For environment protection do not discard the 
unit with usual household waste after its ser-
vice life expiration; apply to a specialized cen-
ter for further recycling.

 •

Keep the unit out of reach of children and dis-
abled persons.

THE  UNIT  IS  INTENDED  FOR  HOUSEHOLD 
USAGE ONLY

BEFORE THE FIRST USE

After  unit  transportation  or  storage  under 
cold  (winter)  conditions,  it  is  necessary  to 
keep it for at least three hours at room tem-
perature.
There  may  be  water  spots  in  the  air  humidi-
fier, this is normal, as the unit has undergone 
factory quality control.

– 

Unpack  the  unit,  remove  any  stickers  and 
package materials that can prevent unit oper-
ation. Check the unit for damages. In case of 
damages do not switch the unit on.

– 

Before  plugging  the  unit  in  make  sure  that 
your home mains voltage corresponds to the 
unit operating voltage.

Notes:
Use  the  air  humidifier  at  the  room  temperature 
from  +10°  С  to  +40°С,  and  relative  humidity  less 
than 80%.
Water temperature should not exceed +40°С.

USING THE AIR HUMIDIFIER

– 

Remove the nozzle (7).

– 

Take  the  water  tank  by  the  handle  (8)  and 
remove it from the unit body (12).

– 

Turn  over  the  tank  (6),  unscrew  the  lid  (11) 
rotating it counterclockwise. 

– 

Fill  the  tank  (6)  with  necessary  amount  of 
water, insert the lid (11) into the water inlet (9) 
and screw it rotating clockwise.

– 

First place the filled water tank (6) back to its 
place and then install the nozzle (7).

– 

Wait till the process chamber (4) is filled with 
water.

Note:

– 

Before the first use it is recommended to put 
the  mineral  filter  (10)  into  a  container  filled 
with  water  of  room  temperature  for  several 
minutes.

– 

Remove  the  filter  (10)  from  the  lid  (11)  turn-
ing it counterclockwise, put the filter (10) into 
water  for  several  minutes,  take  the  filter  out 
and  drain  the  remaining  water,  then  install  it 
back on the lid (11), turning it clockwise until 
bumping.

– 

Insert the power plug into the mains socket.

– 

Switch  the  unit  on  touching  the  button  (13), 
you  will  hear  a  sound  signal  and  the  unit 
will  be  switched  on  with  the  maximal  «mist» 
release  intensity;  the  following  icons  will  be 
shown on the display (2): relative room humid-
ity icon (19), «mist» release intensity icon (20), 
icon crawline (23).

– 

To switch the air humidifier off touch the but-
ton (13) again.

– 

Unplug the unit.

Notes:

– 

The  operation  mode  selection  and  setting 
buttons on the control panel (3) are sensory, 
you just need to touch the button to switch the 
necessary operation mode on. 

– 

The  humidity  level  icons  (19)  shown  on  the 
display  (2)  may  be  slightly  different  from  the 
readings of another hygrometer.

– 

The humidity level indications depend on the 
room temperature.

IM VT-2335.indd   4

27.02.2017   17:35:46

Характеристики

Оцените статью
tehnopanorama.ru
Остались вопросы?

Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)

Задать вопрос

Часто задаваемые вопросы
Как посмотреть инструкцию к VITEK VT-2335 BK?
Необходимо подождать полной загрузки инструкции в сером окне на данной странице
Руководство на русском языке?
Все наши руководства представлены на русском языке или схематично, поэтому вы без труда сможете разобраться с вашей моделью
Как скопировать текст из PDF?
Чтобы скопировать текст со страницы инструкции воспользуйтесь вкладкой "HTML"