Timberk THU UL 15M (M4) - Инструкция по эксплуатации - Страница 6

www.timberk.com • ultrasonic humidifier

6

9. TROUBLESHOOTING

In case of emergency, please, use the troubleshooting methods shown in 

tables. If it is impossible to solve problems with these methods, apply to 

the service center.
Table 2

Problem

Possible cause

Remedy

Poor atomizing (insufficient 

capacity)

The unit is operating in the minimized 

mode (low atomizing frequency)

There is no problem. If you need to switch 

to the intensive mode of operation, turn the 

regulator handle all the way to the right

The atomizer is clogged

Clean the atomizer

Temperature of water in the tank 

is too low

Set maximum capacity. The humidifier’s 

capacity will go up after a while.

No atomizing

The power cord is poorly connected 

to the outlet

Connect the power cord into the outlet 

carefully

There is white deposit on objects 

around the humidifier (salts, 

separating out from water)

1. Lime deposits have formed on the 

membrane

2. There is a lot of salts in the water 

used (calcium and magnesium)

1. Clean the humidifier’s membrane with 

a special brush

2. Use filtered water

Steam has an unpleasant odor

Stale water is used

Clean the unit according to the cleaning 

and servicing instructions and fill the tank 

with fresh water

Remains of stale water or waste have 

accumulated in the unit’s case or 

the atomizer

Condensate is formed on the 

upper part of the humidifier and 

on surrounding objects, when it 

is operating

1. High humidification intensity is set

2. High room humidity and 

temperature

Lower the humidification intensity by turn-

ing the on/off and steam outflow intensity 

regulator counterclockwise.

Water appears next to the humidi-

fier, when it is operating

1. High humidification intensity is set.

2. Lime deposits have formed on the 

membrane and in grooves for water 

(in the unit’s base)

1. Lower the humidification intensity by 

turning the on/off and steam outflow 

intensity regulator counterclockwise

2. Clean the unit according to the cleaning 

and servicing instructions

Water appears next to the humidifi-

er, when it is not operating

Water tank is leaking

You need to contact an authorized service 

center

Service life of the humidifier is 2 years.
At the end of its service life the humidifier should be utilized in accordance 

with regulations and procedures, which are in force at the place of utilization.

11. DISPOSAL

10. TRANSPORTATION AND STORAGE

1. When transporting, any possible impacts and movements of the 

package inside a vehicle must be avoided. 
2. Handling symbols on the unit’s package must be strictly observed when 

transporting and storing it.
3.

Temperature 

requirements*
Humidity 

requirements*

Transportation and 

storage

-30°C to +50°C

15% to 85%       

(no condensate)

We are researching new technologies and constantly improving the quality 

of our products. Specifications, design and scope of delivery may be 

changed without any prior notice.

* Products must be stored in dry, ventilated storages at the temperature not lower than +5°C.