Russell Hobbs 28370-56 - Инструкция по эксплуатации - Страница 6

6

FILLING

1. 

Place the steamer as shown (Fig. E). You can also place your steamer on the heat resistant storage 

bag.

2. 

Open the water inlet cover (Fig. B).

3.  Pour slowly, to let the air in the reservoir escape, otherwise you’ll cause an air lock and the water will 

overflow.

4.  Don’t fill past the 

max

 marking or water will escape in use.

• 

To refill at any time during use, turn the steamer off by pressing the power button until the blue 

indicator light goes out, unplug from outlet, and follow the above procedure.

• 

After refilling, allow to reheat for 60 seconds and then prime the pump by holding the steam trigger 

until steam forms.

USING

• 

If the label says “do not iron” or shows this icon 

i

, fit the delicate attachment and make sure to test 

on an inconspicuous area prior to steaming the entire garment.

• 

If the label says “do not steam” or shows this icon 

m

, do not steam the garment.

1. 

Hang the garment in an area that will not be affected or damaged by the heat and steam, such as on 

a shower curtain rail, or in an open doorway. Alternatively, place the garment on a bed or towel. You 

can use the heat resistant bag between the bed/towel and garment if required.

2. 

Fit any attachment you wish to use.

3.  Plug the steamer in then press the power button. The blue power button light will slowly flash, 

indicating that the steamer is heating.

4.  After about 60 seconds the power light will stay on, indicating your steamer is ready to use. 

5.  Prime the water pump by holding steam trigger until steam forms.

6.  To generate steam, press the steam trigger. As long as the trigger is held, steam will emit from the 

steamer. When the trigger is released, the steam will stop.

• 

To generate a constant flow of steam without holding the trigger, press the steam trigger and then 

slide the steam trigger lock downwards. You can then release pressure on the steam trigger. To turn 

the steam off, press the trigger, slide the steam trigger lock upwards, then release the trigger.

7. 

With your free hand keep the fabric taut. Steam the garment with slow, downward strokes, keeping 

the head of the steamer in contact with the fabric (Fig. C).

8.  When you have finished, press and hold the power button until the blue light goes out (about 3 

seconds) and unplug. 

• 

After ironing or between garments, set your steamer down with the handle resting on a flat, stable 

surface. You can use the heat resistant bag to rest your steamer on (Fig. E).

Ceramic heated plate

Your steamer features a ceramic heated plate that helps smooth out wrinkles and creases on the areas of 

garments that are more difficult to reach with steam alone. The temperature of the plate is safe for all 

ironable fabrics. 

To use, hold the plate of the steamer directly against the fabric. Don’t fit any of the attachments. Steam the 

garment with slow, downward strokes, keeping the head of the steamer in contact with the fabric. You can 

use the heat resitant bag to iron on (Fig D). 

Important

: Always make sure that the surface you use to iron on will not be affected or damaged by heat 

or steam!

Auto shut off

If you haven’t used the steam trigger for approximately 8 minutes, your steamer will enter auto shut off 

mode. In auto shut off mode, the blue light will flash. To restart your steamer, press and hold the steam 

trigger for a few seconds until your steamer begins to steam again and the blue light stops flashing.