Утюги Ardesto IR-C2232 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
EN
16
EN
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate
fabrics.
Always iron these fabrics at low temperatures. The plate may cool down
to the point where no more steam comes out, but rather drops of boiling
water that can leave marks or stains. In these cases, the Anti-drip system
automatically activates to prevent vaporization, so that you can iron the
most delicate fabrics without risk of spoiling or staining them.
AUTOMATIC SHUT OFF
The automatic shut off device trips after the iron has been left for approx.
eight minutes in the upright position or unused for approx. Thirty seconds
in the horizontal position. The light comes on to indicate that shut off has
tripped. As soon as you move the iron, the device turns off and the iron
starts working again.
GENERAL INSTRUCTIONS
When using the iron for the first time, you may notice a slight emission
of smoke and hear some sounds made by the expanding plastics. This is
quite normal and it stops after a short time. We also recommend passing
the iron over an ordinary cloth before using it for the first time.
PREPARATIONS
Soft the laundry to be ironed according to the international symbols on
the garment label, or if this is missing, according to the type of fabric.
GARMENT
LABEL
FABRIC
TYPE
THERMOSTAT
REGULATION
Synthetic
•
Low temperarure
Silk - wool
• •
Medium temperarure
Сotton - linen
• • •
High temperarure
Fabric not to be ironed
3
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale
build-up in the plate. The resin filter is permanent and does not need replacing.
Please note:
Use tap water only. Distilled and/demineralised water makes the
“
Zero-Calc
”
anti-calc system ineffective by altering its physicochemical
characteristics.
Do not use chemical additives, scented substances or decalcifiers. Failure to
comply with the above-mentioned regulations leads to the loss of guarantee.
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point
where no more steam comes out, but rather drops of boiling water that can leave
marks or stains. In these cases, the Anti-drip system automatically activates to
prevent vaporization, so that you can iron the most delicate fabrics without risk of
spoiling or staining them.
AUTOMATIC SHUT OFF
The automatic shut off device trips after the iron has been left for approx. eight
minutes in the upright position or unused for approx. Thirty seconds in the horizontal
position. The light comes on to indicate that shut off has tripped. As soon as you
move the iron, the device turns off and the iron starts working again.
G E N E R A L I N S T R U C T I O N S
When using the iron for the first time, you may notice a slight emission of smoke
and hear some sounds made by the expanding plastics. This is quite normal and it
stops after a short time. We also recommend passing the iron over an ordinary cloth
before using it for the first time.
PREPARATIONS
Soft the laundry to be ironed according to the international symbols on the garment
label, or if this is missing, according to the type of fabric.
GARMENT
LABEL
FABRIC
TYPE
THERMOSTAT
REGULATION
synthetic
·
low temperature
silk - wool
··
medium temperature
Cotton - linen
··
·
high temperature
Fabric not to be ironed
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down)
and eliminates the risk of scorching the fabric.
STEAM IRONING
Filling the reservoir
- Check that the plug is disconnected from the socket.
- Move the steam selector (3) to “
0
”
[Fig. 1]
.
- Open the lid (2).
- Raise the tip of the iron to help the water enter the opening without overflowing.
- Slowly pour the water into the reservoir using the special measure (18) and taking
care not to go over the maximum level indicated by “
MAX
” on the reservoir
[Fig.
2]
.
- Close the lid (2).
3
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale
build-up in the plate. The resin filter is permanent and does not need replacing.
Please note:
Use tap water only. Distilled and/demineralised water makes the
“
Zero-Calc
”
anti-calc system ineffective by altering its physicochemical
characteristics.
Do not use chemical additives, scented substances or decalcifiers. Failure to
comply with the above-mentioned regulations leads to the loss of guarantee.
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point
where no more steam comes out, but rather drops of boiling water that can leave
marks or stains. In these cases, the Anti-drip system automatically activates to
prevent vaporization, so that you can iron the most delicate fabrics without risk of
spoiling or staining them.
AUTOMATIC SHUT OFF
The automatic shut off device trips after the iron has been left for approx. eight
minutes in the upright position or unused for approx. Thirty seconds in the horizontal
position. The light comes on to indicate that shut off has tripped. As soon as you
move the iron, the device turns off and the iron starts working again.
G E N E R A L I N S T R U C T I O N S
When using the iron for the first time, you may notice a slight emission of smoke
and hear some sounds made by the expanding plastics. This is quite normal and it
stops after a short time. We also recommend passing the iron over an ordinary cloth
before using it for the first time.
PREPARATIONS
Soft the laundry to be ironed according to the international symbols on the garment
label, or if this is missing, according to the type of fabric.
GARMENT
LABEL
FABRIC
TYPE
THERMOSTAT
REGULATION
synthetic
·
low temperature
silk - wool
··
medium temperature
Cotton - linen
··
·
high temperature
Fabric not to be ironed
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down)
and eliminates the risk of scorching the fabric.
STEAM IRONING
Filling the reservoir
- Check that the plug is disconnected from the socket.
- Move the steam selector (3) to “
0
”
[Fig. 1]
.
- Open the lid (2).
- Raise the tip of the iron to help the water enter the opening without overflowing.
- Slowly pour the water into the reservoir using the special measure (18) and taking
care not to go over the maximum level indicated by “
MAX
” on the reservoir
[Fig.
2]
.
- Close the lid (2).
3
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale
build-up in the plate. The resin filter is permanent and does not need replacing.
Please note:
Use tap water only. Distilled and/demineralised water makes the
“
Zero-Calc
”
anti-calc system ineffective by altering its physicochemical
characteristics.
Do not use chemical additives, scented substances or decalcifiers. Failure to
comply with the above-mentioned regulations leads to the loss of guarantee.
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point
where no more steam comes out, but rather drops of boiling water that can leave
marks or stains. In these cases, the Anti-drip system automatically activates to
prevent vaporization, so that you can iron the most delicate fabrics without risk of
spoiling or staining them.
AUTOMATIC SHUT OFF
The automatic shut off device trips after the iron has been left for approx. eight
minutes in the upright position or unused for approx. Thirty seconds in the horizontal
position. The light comes on to indicate that shut off has tripped. As soon as you
move the iron, the device turns off and the iron starts working again.
G E N E R A L I N S T R U C T I O N S
When using the iron for the first time, you may notice a slight emission of smoke
and hear some sounds made by the expanding plastics. This is quite normal and it
stops after a short time. We also recommend passing the iron over an ordinary cloth
before using it for the first time.
PREPARATIONS
Soft the laundry to be ironed according to the international symbols on the garment
label, or if this is missing, according to the type of fabric.
GARMENT
LABEL
FABRIC
TYPE
THERMOSTAT
REGULATION
synthetic
·
low temperature
silk - wool
··
medium temperature
Cotton - linen
··
·
high temperature
Fabric not to be ironed
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down)
and eliminates the risk of scorching the fabric.
STEAM IRONING
Filling the reservoir
- Check that the plug is disconnected from the socket.
- Move the steam selector (3) to “
0
”
[Fig. 1]
.
- Open the lid (2).
- Raise the tip of the iron to help the water enter the opening without overflowing.
- Slowly pour the water into the reservoir using the special measure (18) and taking
care not to go over the maximum level indicated by “
MAX
” on the reservoir
[Fig.
2]
.
- Close the lid (2).
3
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale
build-up in the plate. The resin filter is permanent and does not need replacing.
Please note:
Use tap water only. Distilled and/demineralised water makes the
“
Zero-Calc
”
anti-calc system ineffective by altering its physicochemical
characteristics.
Do not use chemical additives, scented substances or decalcifiers. Failure to
comply with the above-mentioned regulations leads to the loss of guarantee.
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point
where no more steam comes out, but rather drops of boiling water that can leave
marks or stains. In these cases, the Anti-drip system automatically activates to
prevent vaporization, so that you can iron the most delicate fabrics without risk of
spoiling or staining them.
AUTOMATIC SHUT OFF
The automatic shut off device trips after the iron has been left for approx. eight
minutes in the upright position or unused for approx. Thirty seconds in the horizontal
position. The light comes on to indicate that shut off has tripped. As soon as you
move the iron, the device turns off and the iron starts working again.
G E N E R A L I N S T R U C T I O N S
When using the iron for the first time, you may notice a slight emission of smoke
and hear some sounds made by the expanding plastics. This is quite normal and it
stops after a short time. We also recommend passing the iron over an ordinary cloth
before using it for the first time.
PREPARATIONS
Soft the laundry to be ironed according to the international symbols on the garment
label, or if this is missing, according to the type of fabric.
GARMENT
LABEL
FABRIC
TYPE
THERMOSTAT
REGULATION
synthetic
·
low temperature
silk - wool
··
medium temperature
Cotton - linen
··
·
high temperature
Fabric not to be ironed
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down)
and eliminates the risk of scorching the fabric.
STEAM IRONING
Filling the reservoir
- Check that the plug is disconnected from the socket.
- Move the steam selector (3) to “
0
”
[Fig. 1]
.
- Open the lid (2).
- Raise the tip of the iron to help the water enter the opening without overflowing.
- Slowly pour the water into the reservoir using the special measure (18) and taking
care not to go over the maximum level indicated by “
MAX
” on the reservoir
[Fig.
2]
.
- Close the lid (2).
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
