Philips GC8715 - Инструкция по эксплуатации - Страница 12

14

English

Troubleshooting

This chapter summarizes the most common problems you could encounter 
with the appliance. If you are unable to solve the problem with the 
information below, visit

 www.philips.com/support 

for a list of frequently 

asked questions or contact the Consumer Care Center in your country.

Problem

Possible cause

Solution

The iron does not 
produce any steam.

There is not enough water in 
the water tank.

Fill the water tank beyond the MIN 
indication. Press and hold the steam trigger 
until steam comes out. It may take up to 30 
seconds until steam comes out.

You did not press the steam 
trigger.

Press and hold the steam trigger until 
steam comes out.

The steam function has 
been disabled until you 
have performed the Calc-
Clean process.

Perform the Calc-Clean process to restore 
the steam function. (see chapter ' Cleaning 
and maintenance')

The water tank is not placed 
in the appliance properly. 

Fit the water tank back into the appliance 
firmly ('click').

At the start of your ironing 
session, the steam trigger 
has not been pressed long 
enough.

Press and hold the steam trigger until 
steam comes out. It may take up to 30 
seconds until steam comes out.

The light of the CALC-
CLEAN button flashes 
and the appliance beeps.

This is the Calc-Clean 
reminder.

Perform the Calc-Clean after the Calc-
Clean reminder is given (see chapter 
'Cleaning and maintenance').

No steam comes out of 
the soleplate, the light 
of the CALC-CLEAN 
button flashes and the 
appliance beeps.

You have not done or have 
not completed the Calc-
Clean process.

Perform the Calc-Clean process to enable 
the steam function again (see chapter 
'Cleaning and maintenance').

The appliance has 
switched off.

The safety auto-off function 
is activated automatically 
when the appliance has not 
been used for more than 5 
minutes.

To activate the appliance again, press the 
on/off button. The appliance then starts to 
heat up again.

The appliance produces 
a loud pumping sound.

The water tank is empty. 

Fill the water tank with water and press 
the steam trigger until the pumping sound 
becomes softer and steam comes out of 
the soleplate.

Water droplets come out 
of the soleplate.

After the Calc-Clean process 
remaining water may drip 
out of the soleplate.

Wipe the soleplate dry with a piece of cloth. 
If the Calc-Clean light still flashes and the 
appliance still beeps, perform the Calc-
Clean process (see chapter 'Cleaning and 
maintenance').