Утюги Philips GC8520/02 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Problem
Possible cause
Solution
Wet spots appear
on the garment
during ironing.
The wet spots that appear on your
garment after you have steam ironed
for some time may be caused by
steam that has condensed onto the
ironing board.
Iron the wet spots without steam
for some time to dr y them. If the
underside of the ironing board is
wet, wipe it dr y with a piece of dr y
cloth.
Water leaks from
the appliance.
If you tilt the steam generator during
transpor t or place it on an uneven
surface when the water tank is full,
water may spill out of the water tank.
Do not tilt the appliance when the
water tank is full.
Water spots
appear on the
garment during
use of the steam
boost function.
The water spots on your garment are
due to condensation in the supply
hose. When the supply hose cooled
down, the steam that was still present
in the hose cooled down and
condensed into water.
The water droplets stop coming out
of the appliance when you have
used the steam boost function for
some time.
Flakes and
impurities come
out of the
soleplate or the
soleplate is dir ty.
Impurities or chemicals present in the
water have deposited in the steam
vents and/or on the soleplate.
Clean the soleplate with a damp
cloth.
Too much scale and minerals have
accumulated inside the steam
generator.
Rinse the steam generator
frequently (see chapter ‘Cleaning
and maintenance’).
The steam supply
hose is warm
during ironing.
This is normal as steam passes
through the steam supply hose during
steam ironing.
Place the steam supply hose on the
opposite side of the ironing board
in such a way that your hand does
not touch the hose during ironing.
I cannot put the
iron on its heel.
The iron cannot be put on its heel
because it has an ergonomic
design that reduces strain on your
wrist (see chapter ‘Introduction’).
Place the iron horizontally on the
heat-resistant iron resting mat.
GC8565/GC8560
only: The cord is
not wound
completely when I
press the
cord rewind
button
The cord jammed during rewinding.
Pull a small par t of the cord out of
the appliance and press the cord
rewind button again.
EnGlish
11
