Philips GC7933/30 - Инструкция по эксплуатации - Страница 7

9

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you 

are unable to solve the problem with the information below, visit

 www.philips.com/support 

for a list 

of frequently asked questions or contact the Consumer Care Center in your country.

Problem

Possible cause

Solution

The iron does not 

produce any steam.

There is not enough water in 

the water tank.

Fill the water tank. Press and hold the 

steam trigger until steam comes out. It 

may take up to 30 seconds until steam 

comes out.

You did not press the steam 

trigger.

Press and hold the steam trigger until 

steam comes out.

The steam function has 

been disabled until you have 

performed the Calc-Clean 

process.

Perform the Calc-Clean process to 

restore the steam function. (see chapter 

‘Cleaning and maintenance’)

At the start of your ironing 

session, the steam trigger 

has not been pressed long 

enough.

Press and hold the steam trigger until 

steam comes out. It may take up to 30 

seconds until steam comes out.

No steam comes out of 

the soleplate, the light 

of the CALC CLEAN 

button flashes and the 

appliance beeps.

You have not done or have 

not completed the Calc-Clean 

process.

Perform the Calc-Clean process to 

enable the steam function again (see 

chapter ‘Cleaning and maintenance’).

Water droplets come out 

of the soleplate.

After the Calc-Clean process 

remaining water may drip out 

of the soleplate.

Wipe the soleplate dry with a piece of 

cloth. If the Calc-Clean light still flashes 

and the appliance still beeps, perform 

the Calc-Clean process (see chapter 

‘Cleaning and maintenance’).

You have used the steam 

boost function too frequently.

Use the steam boost function only for 

stubborn creases. It is recommended not 

to use it for more than 5 times within 3 

minutes.

The Calc-Clean process has 

not been completed.

You have to perform the Calc-Clean 

process again (see chapter ‘Cleaning and 

maintenance’).

Steam condenses into water 

in the hose when you use 

steam for the first time or 

have not used it for a long 

time.

This is normal. Hold the iron away from 

the garment and press the steam trigger.

Wait until steam instead of water comes 

out of the soleplate.

Dirty water and 

impurities come out of 

the soleplate.

Impurities or chemicals 

present in the water have 

deposited in the steam vents 

and/or soleplate.

Perform the Calc-Clean process 

regularly (see chapter ‘Cleaning and 

maintenance’).

Water flushes out of the 

soleplate.

You have accidentally started 

the Calc-Clean process 

(see chapter ‘Cleaning and 

maintenance’).

Switch off the appliance. Then switch it 

back on again. Let the iron heat up until 

the ‘iron ready’ light lights up steadily.

The Calc-Clean process 

does not start.

You have not pressed the 

CALC-CLEAN button for 

2 seconds until the appliance 

started beeping.

See chapter ‘Cleaning and maintenance’.

English