Philips GC2860/02 - Инструкция по эксплуатации - Страница 16

Problem

Cause

Solution

The set 

temperature is too 

low for steam 

ironing.

Set an ironing temperature 

that is suitable for steam 

ironing ( 

2

 to MAX). Put the 

iron on its heel and wait until 

the temperature light goes out 

before you star t ironing.

You have put an 

additive in the 

water tank.

Rinse the water tank and do 

not put any additive in the 

water tank.

You have used the 

steam boost 

function at a 

setting below  

3

.  

Set the temperature dial to a 

setting between  

3

 and 

MAX.

You have used the 

steam boost 

function too often 

within a shor t 

period.

Continue ironing in horizontal 

position and wait a while 

before you use the steam 

boost function again.

Water drips 

from the 

soleplate after 

the iron has 

cooled down or 

has been stored.

You have put the 

iron in horizontal 

position while 

there was still 

water in the water 

tank.

Empty the water tank and set 

the steam control to position 

0 after use. Store the iron on 

its heel.

Water spots 

appear on the 

garment during 

ironing.

These wet spots 

may be caused by 

steam that has 

condensed onto 

the ironing board.

Iron wet spots without steam 

from time to time to dr y them.

EnGlISh

16

4239.000.7163.1.indd   16

20-05-09   09:02