Braun TexStyle TS505 - Инструкция по эксплуатации - Страница 11

11

6)  Use a non-metallic brush until all openings 

are clean.

7)  Rinse under running water.

8)  Re-insert the steam button. 

9)  Press to check the steam on/off function.

Note: the iron must never be used without 
the steam button.

H  Decalcifying / anticalc system

When scale particles come out of the steam 
vents or when the steam development is 
insuffi cient even after cleaning the 
anticalc valve, you should clean the steam 
chamber as follows:

1)  Make sure the steam button is in its lower 

position.

2) – 3) Fill water into the tank, connect to the 

mains and select the «•••» temperature 
setting.

4) – 5) Wait until the pilot light turns off. 

Unplug the iron.

6) – 7) Hold the iron over a sink, then press the 

steam button so it is lifted, carefully pull it 
up, turn it and rest it in this position.

Caution: When the steam button is pulled 
up, hot water and steam will come out 
from the sole plate.

8)  Push back the steam button until it catches 

in the lower position.

9) – 10) Fill water into the tank, connect to the 

mains and select the «•••» temperature 
setting.

11) –13) When the pilot light goes off, press 

the power shot button 4 times to rinse the 
iron. Disconnect the iron and wait for the 
sole plate to cool off, then clean it as 
described above in section «G».

Note: the iron must never be used without 
the steam button.

Trouble-shooting guide

Problem

Remedy

Drops coming 
out of the steam 
vents

Turn the steam 
regulator counter-
clockwise to reduce 
the steam or press the 
steam button to turn 
the steam off. 
Take longer intervals 
when pressing the 
power shot button.
Select a higher 
tempera ture setting.

No steam 
at all

Press the steam button 
so that it is lifted.

Less steam 
develops or 
no steam at all

Clean the anticalc 
valve (see «G»).

Calcium par-
ticles coming 
through the steam 
vents

Decalcify the steam 
chamber (see «H»).

Subject to change without notice.

Please do not dispose of the 
product in the household waste at the 
end of its useful life. Disposal can take 
place at a Braun Service 
Centre or at appropriate collection 
points provided in your country.

5712710034_TS_545-505_S06-80.indd   11

5712710034_TS_545-505_S06-80.indd   11

03.06.13   10:42

03.06.13   10:42