Braun TexStyle TS505 - Инструкция по эксплуатации - Страница 10

10

• 

Keep the iron in the upright position and 
connect it to the mains. Select the tem-
perature according to the ironing guide on 
the heel rest of the iron or on the label in 
your garments.

• 

The temperature pilot light (7) goes off, 
when the desired temperature is reached 
(after approx. 1 minute).

C Ironing 

1 Steam 

on/off 

For steam ironing the temperature selector 
(6) must be set according to drawing C1 
from greater than «••» to «

max

».  

Press the steam button (3) to start the 
steam mode.

steam on

steam off

With the steam button in its upper position 
(steam on), turn the steam regulator (3a) 
to adjust the steam quantity.

We recommend a medium steam setting 
for all normal ironing. Only when ironing 
linen, thick cotton or similar fabrics we 
recommend the maximum steam setting.

Preconditioning
Steam develops also horizontally at the 
front area of the sole plate. This precondi-
tions the textiles by «pre-steaming», thus 
making ironing easier. 
Be careful – steam comes out laterally.

2 Power 

shot 

Prior to use, press the power shot button 
(5) 3 to 4 times to activate it. Press the 
power shot button in intervals of at least 
5 seconds. 
Power shot can be activated when dry 
ironing. However, the temperature selector  
has to be set in the range between «•••» 
to «

max

». The power shot function can 

also be used in the vertical position for 
steaming hanging clothes.

3 Spray 

function 

Press the spray button (4). 

4 Dry 

ironing 

Turn the steam mode off by pressing the 
steam button (3) so that it catches in the 
lower position.

 Automatic 

shut-off 

(model TS 525 A only)

The auto-off mechanism causes a slight 
rattling noise during ironing. This is  normal 
and in no case indicates a fault of the iron.
The «auto-off» light (8) will fl ash when the 
automatic shut-off is activated.
This happens when the iron has rested …
–  horizontally on its sole plate for about 

30 seconds or

–  vertically on its heel rest for about 

8 minutes.

To turn on the iron again, just move it.
When the temperature pilot light stops 
fl ashing, the electrical power is on again.
The automatic shut-off will be activated 
approximately 2 minutes after the iron is 
plugged into a socket.

D Textile Protector 

 (model 

TS

535 TP, TS

545 TP S only)

The Braun Textile Protector protects 
delicate fabrics from heat damage and 
makes it possible to iron most dark fabrics 
without an intermediate cloth. To check 
the reaction of your fabrics before you 
start ironing, we recommend that you iron 
a small section of material on the reverse 
side. With the Protector, you are able to 
iron delicate fabrics with the temperature 
setting «•••» to «

max

», so that you can 

use all steam functions your iron offers.
After having attached the Textile Protector, 
wait about 1 ½ minutes before you start 
ironing. 

E After ironing

• 

Unplug the iron and press the steam on/off 
button (3) so that it catches in its lower 
position (steam off). 

• 

To prolong the life of the iron, empty the 
water tank. 

• 

Store the cool iron in a dry place always 
standing on its heel rest.

F  Maintenance and cleaning

To clean the sole plate, use steel wool. 
Then wipe the sole plate clean with a cloth. 
Never use a scouring pad, vinegar nor 
other chemicals. To clean the soft material 
of handle and power shot and spray 
buttons, use soapy water.

G  Cleaning the anticalc valve

The iron’s anticalc valve is located at the 
lower end of the steam button (3). It has 
to be decalcifi ed regularly (e.g. when the 
steam development is insuffi cient). 
Proceed as follows:

1)  Unplug the iron and empty the water tank.

2)  Press the steam button so it is lifted.

3)  Remove carefully (some water may now 

leak from the sole plate).

4)  Do not touch the anticalc valve.

5)  Immerse in vinegar (not vinegar essence) 

or lemon juice until the lime becomes soft.

5712710034_TS_545-505_S06-80.indd   10

5712710034_TS_545-505_S06-80.indd   10

03.06.13   10:42

03.06.13   10:42