Утюги Bosch Sensixx’x DA30 TDA3024050 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
17
B O S C H
* Model dependent
EN
gl
ISH
Trouble shooting
Problem
Probable cause
Solution
The iron does not
heat up.
1. Temperature control (12) set to
minimum.
2. The “secure” system has been
activated (“auto off” indicator light
15* flashes). The iron is set to
stand-by.
3. The “SensorSecure”* system has
been activated (“SensorSecure”
indicator light 16* flashes). The iron
is set to stand-by.
1. Turn to a higher position.
2. To reconnect the iron, just move it
about gently.
3. Grip the handle of the iron to re-start it.
The clothes tend
to stick.
1. The temperature is too high.
1. Turn the temperature control (12) down
and wait until the iron has cooled down.
Water drips out of
the soleplate (7)
together with
steam.
1. Temperature control (12) setting is
too low.
2. Steam regulator (3) is set too high in
conjunction with a low temperature.
3. You have pressed the shot of steam
button (2) repeatedly without waiting
for 5 seconds between each press.
1. Turn the temperature control to a higher
setting (between “••” and “max”) and
wait until the pilot light (13) goes out.
2. Set the steam regulator (3) to a lower
setting.
3. Wait 5 seconds between each press of
the shot of steam button.
Steam does not
come out.
1. Steam regulator (3) is set to
[
]
position.
2. The temperature is too low. Anti-drip
system is activated.
1. Set the steam regulator to a higher
position.
2. Set to a higher temperature if
compatible with the fabric.
Smoke comes out
when connecting
the iron for the first
time.
1. This may be caused by the
lubrication of some of the internal
parts.
1. This is normal and will stop after a few
minutes.
Excessive dripping
or steaming.
1. No proper closing of “Calc’nClean”
system.
1. Actuate a few times the “clean” button
(10).
Deposits come out
through the holes
in the soleplate
(7).
1. Traces of lime scale are coming out
of the steam chamber.
1. Carry out a cleaning cycle (see
“Calc’nClean” section).
If none of the above solves the problem, get in touch with an authorised technical service.
The descaling liquid may be purchased from our
after-sales service or specialist shops.
Name of accessory: TDZ1101
D
anti-calc*
The “anti-calc” cartridge has been designed to
reduce the build-up of scale produced during
steam ironing, helping to extend the useful life of
your iron. Nevertheless the “anti-calc” cartridge
cannot remove all of the scale that is produced
naturally over time.
