Makita RBC414U - Инструкция по эксплуатации - Страница 15

(3)

(1)

(2)

(4) 

(5)

Starting

Move at least 3m (10ft) away from the place of refuelling. Place the brushcutter on a clean piece of ground taking care that the cutting tool does 

not come into contact with the ground or any other objects.

First place the machine on the ground.

–

Give a gentle push on the primer pump (4) repeatedly (7-10 times) until fuel 

–

comes into the primer pump.

Move the choke lever (5) to the top position (

–

).

Firmly hold the unit by your left hand, as illustrated.

–

Slowly pull the starter grip until resistance is felt and continue with a smart pull.

–

Do not pull out the starter rope to its full extent and do not allow the starter handle 

–

to be retracted without control, but ensure that it is retracted slowly.

Repeat the starting operation until initial ignitions are heard.

–

Depress the choke lever (

–

) and pull the starter rope again until the engine 

starts.

As soon as the engine starts, immediately tap and release the throttle, thus 

–

releasing the half-throttle lock so that the engine can run in idle.

Run the engine for approximately one minute at a moderate speed before 

–

applying full throttle.

Caution during operation:

If the throttle lever is opened fully in a no-load operation, the engine rotation is increased to 10,000 min

-1

 or more. Never operate the engine at a 

higher speed than required and at an approximate speed of 6,000 - 8,000 min

-1

.

Cold start

Grasp the handle (hand pressure activates the safety lock-off lever (1)).

–

Press the throttle lever (2) and hold it down.

–

Push the I-O switch (3) to START.

–

PUTTING INTO OPERATION

Observe the applicable accident prevention regulations!

15