Makita RBC413U - Инструкция по эксплуатации - Страница 9

(2)

(1)

CAUTION:   Before doing any work on the brushcutter, always switch off the motor 

and pull the spark plug connector off the spark plug. 

Always wear protective gloves.

CAUTION:   Start the brushcutter only after having assembled it completely.

After checking the parts, fasten the drive shaft to the engine with four bolts 

–

M6 x 20 (1). At this time, fasten also the earth terminal (2) of the stop cord to the 

engine.

CAUTION:  Before doing any work on the brushcutter, always stop the engine and 

pull the spark plug connector off the spark plug. Always wear protective 

gloves!

CAUTION: Start the brushcutter only after having assembled it completely.

For model RBC413U

Place the handle with the throttle lever on the handle holder on the right side (to 

–

be held by the right hand) and the other on the left side.
Fit the handle edge to the handle holder groove, and provisionally fix the upper 

–

side (1) of the handle holder by four bolts M5 x 25 (2).
Adjust the handle to an angle easy to manipulate, and tighten the bolt (2) 

–

uniformly on the right and left sides.

ASSEMBLY OF ENGINE AND SHAFT

MOUNTING OF HANDLE

(1)

(2)

(3)

(4)

(5)

For model RBC414U

Loosen knob (1).

–

Place handle (4) between handle clamp (2) and handle holder (3).

–

Adjust handle (4) to an angle that provides a comfortable working position and 

–

then secure by firmly hand-tightening knob (1).

CAUTION: Do not forget to mount spring (5).

Engine

9