Триммеры Makita RBC413U - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
IDLE ADJUSTMENT
Never attempt to make engine adjustments while the unit is running and strapped
–
to the operator. Always make engine adjustments with the unit resting on a flat,
clear surface.
The cutter blade or the nylon cutting head should not run when the control lever is
fully released. If necessary, adjust the idle rpm using the idle adjusting screw.
Checking the Idle speed
Idle speed should be set to 2,600 min
–
-1
.
If necessary correct it by means of the idle adjustment screw (the blade or the
nylon cutting head must not turn when the engine is on idle.)
Turning in the screw clockwise will cause an increase in the engine speed,
whereas turning the screw counterclockwise will reduce the engine speed.
CAUTION:
The cutting tools mentioned below must only be resharpened by an authorized
facility. Manual resharpening will result in imbalances of the cutting tool causing
vibrations and damage to the equipment.
cutter blade
–
An expert resharpening and balancing service is provided by Authorized Service
Agents.
NOTE:
To increase the service life of the cutter blade it may be turned over once, until both
cutting edges have become blunt.
RESHARPENING THE CUTTING TOOL
Stopping
1) Release the throttle lever (2) fully, and when the engine rpm has lowered, set the
I-O switch (1) to STOP the engine will now stop.
2) Be aware that the cutting head may not stop immediately and allow it to slow
down fully.
OPERATION OF THROTTLE LEVER
With the throttle lever main unit held by hand (with the lock-off lever pushed), pull
the throttle lever to increase the engine rotation.
Release the throttle lever to let the engine run idle.
Release the hand from the throttle lever main unit. The lock-off lever returns
automatically so that the throttle lever is not pulled by mistake.
(2)
(1)
(1)
(2)
Starting the warm engine
As described above, except without moving the choke lever (choke lever remains in the down position).
–
increase
Idle adjusting
screw
reduce
16
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
