BRAYER BR4800 - Инструкция по эксплуатации - Страница 7

7

EN

•  To increase the air temperature in the room, turn 

the thermostat control knob (6) clockwise and 

counterclockwise to decrease it.

• 

Note:

 — the fan heater will not switch on if the 

thermostat settings correspond to the air temperature 

in the room.

•  To switch the oscillation mode on, press the 

button (3). Press the button (3) again to switch the 

oscillation mode off.

• 

After the unit operation is finished, turn the 

thermostat control knob (6) counterclockwise as far 

as it will go and set the operation mode switch (5) to 

the position «0» and unplug the unit.

• 

Note: 

— when you switch the unit on for the first 

time, some smoke or foreign odor may appear. It is 

normal and not covered by warranty.

AUTOMATIC EMERGENCY SWITCH-OFF 

FUNCTION IF THE OUTGOING AIR IS TOO 

HOT

•  If the outgoing air temperature exceeds the 

acceptable value, the automatic thermal switch will 

switch on, and the fan heater will be switched off.

•  Set the operation mode switch (5) to the position «0» 

and unplug the unit, let the fan heater cool down for 

approximately 15-25 minutes (depending on the air 

temperature in the room) and only after that you can 

switch the unit on again.

•  Make sure that the front (2) and rear grids are not 

blocked with foreign objects.

•  Insert the power plug into the mains socket and 

switch the fan heater on.

• 

If the fan heater does not switch on, it may be caused 

by another malfunction. In this case apply to a 

service center for repairing of the fan heater.

PROTECTION FROM DROPPING

•  If the fan heater accidentally falls or tilts too much, 

the fall protection device will switch on and the fan 

heater will be switched off.

•  Set the fan heater into vertical position, and the unit 

will resume operation.

• 

Note: 

— place the fan-heater on a flat dry and steady 

surface to prevent it from dropping.

CLEANING AND  MAINTENANCE

•  Before cleaning the fan heater set the operation 

mode switch (5) to the position «0», and make sure 

that the power plug is not inserted into the mains 

socket.

• 

Wipe the fan heater body with a slightly damp cloth 

and then wipe it dry.

• 

Do not use liquid detergents, abrasive cleaners and 

any solvents to clean the fan heater.

•  To avoid the risk of electric shock provide that no 

water or other liquid gets into the fan heater body.