Blaupunkt 40FB5000T - Инструкция по эксплуатации - Страница 44

Getting started 

Fitting the stand 

Before you can install your TV set, you need to fit the stand. Alternatively, you can mount it 
on the wall. A Phillips screwdriver is needed to perform the installation. 

Setting up the TV set 

Place your TV set on a flat, stable surface (e.g. a table or a specially designed TV stand). 
Make sure that all cables are laid simply and safely and do not represent a trip hazard. The 
device must be connected to a mains socket using the mains cable. This mains socket must 
be easily accessible so that the mains plug can be removed immediately in the event of an 
emergency. 

Fitting the batteries into the remote control 

1.  Turn the remote control over with its underside facing upwards, insert a finger into the 

recess, and push the battery compartment cover in the direction of the arrow. Remove 
the battery compartment cover. 

2.  Insert the batteries supplied into the remote control. Make sure that you insert the 

batteries correctly with the polarity as shown inside the battery compartment. 

3.  Replace the battery compartment cover and push in the opposite direction to the arrow 

until it clicks into place. 

Caution:

 Remove the batteries from the remote control if you are not going to 

use the device for an extended period of time. Otherwise, the remote control 
can be damaged by leaking battery acid. 

7