GAZER TV32-HS2G - Инструкция по эксплуатации - Страница 10

6

EN

Preparation of the TV Set

Note:

In case of the normal use, new batteries are to operate about half a 

year� If you are not going to use the TV set for a long period of time, remove 

the batteries out of the remote� 

Installation of the TV Set: 

Carry out the operations as follows to use the TV set comfortably and safely:

• 

Carefully  take  the  device  out  of  the  box,  remove  all  transport  means  of 

protection (foam holders, protective wrapping);

• 

In addition, remove the entire protective film from the device;

• 

If you are going to fasten the TV set on the wall with a bracket, use the VESA 

mounting holes on the back cover of the device;

• 

When choosing the installation location, pay attention to the stability of the 

surface� An unstable, rocking piece of furniture may be a cause of the TV-set 

tipping over; 

• 

While fastening the TV set on the wall fixture, be attentive and reliably fasten 

the TV set in order to avoid any injuries from the device fall;

• 

After installing the TV set, plug in the power-supply cable into the socket� Lay 

the power-supply cable so as to avoid any tension or break that may lead to 

the cable damage�

Preparation of the Remote Control

To ensure the operation of the control, it is necessary to insert batteries therein� 

The remote control is powered by two AAA 1�5 V batteries�
The following operations should be carried out to install the batteries inside the 

remote:

• 

Carefully open the cover of the battery section;

• 

Install two batteries in the correct polarity (pursuant to the diagram inside the 

section);

• 

Carefully close the cover of the battery section�