Zanussi ZWQ 61226 SI - Инструкция по эксплуатации - Страница 14

3.

CLEANING THE INLET HOSE AND THE VALVE FILTER

1

2

3

1

2

3

90˚

4

FROST PRECAUTIONS
If the appliance is installed in an area where the

temperature can be less than 0 °C, remove the

remaining water from the inlet hose and the drain

pump.

Do this procedure also when you want

to do the emergency drain.

1. Disconnect the mains plug from the mains

socket.

2. Remove the water inlet hose.

3. Remove the drain hose from the rear support

and unhook it from sink or spigot.

4. Put the ends of the drain and inlet hose in a

container. Let the water flow out of the hoses.

5. Set any selected programme with option Drain

& Spin and let it operate until the end of the

cycle.

6. When no more water flows, install the inlet

hose and the drain hose again.

7. Press the On/Off button to deactivate the

appliance.

WARNING! Make sure that the

temperature is more than 0°C before

you use the appliance again. The

manufacturer is not responsible for

damages caused by low temperatures.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.

INTRODUCTION
The appliance does not start or it stops during

operation.
First try to find a solution to the problem (refer to

the table). If the problem persists, contact the

Authorised Service Centre.
With some problems, the acoustic signals

operate and the display shows an alarm

code:

•

 - The appliance does not fill with water

properly.

•

 - The appliance does not drain the water.

•

 - The appliance lid or drum doors are

open or not closed correctly. Please check

both!

•

 - The mains supply is unstable. Wait until

the mains supply is stable.

•

 - No communication between electronic

elements of the appliance. Switch off and

switch on again.

14