Стиральная машина Zanussi ZWQ 61226 SI - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
STARTING A PROGRAMME WITH THE
FINISH IN OPTION
1. Touch the button
again and again to
choose the number of hours in which you want
the washing cycle to be finished.
The display shows the number of hours you set
(e.g.
) and the indicator above the button
is
on to show that his option is active.
2. Touch the button
:
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Finish In option before you touch
the button
. After touching the
button
you can only cancel the
Finish In option.
To cancel the the Finish In option:
a. Touch the button
to set the appliance
to pause. The indicator of button
flashes.
b. Touch the button
until the indicator
above this button goes off.
Touch the button
again to start the
programme immediately.
When using liquid detergents in
combination with the Finish In option,
add the liquid detergents with a
dosing ball (supplied by the
detergent's manufacturer).
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Touch
.
The indicator of this button flashes.
2. Change the options. If you change any option
the Finish In option (if set) will be disabled.
3. Touch
again.
The programme continues.
CANCELLING A PROGRAMME
1. Press the button for some seconds to
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE LID
While a programme (or the
) operates, the
appliance lid is locked. The indicator
is on.
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the lid.
To open the lid during the first minutes of the
cycle (or when the
operates) :
1. Touch the button
to pause the appliance.
2. Wait a couple of minutes until the indicator
goes off.
3. You can open the lid.
4. Close the lid and touch the button
again.
The programme (or the
) continues.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display comes on.
• The indicator of the button
goes off.
• The lid lock indicator
blinks (when the lid is
unlocking) and then goes off.
• You can open the lid.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Press the button for some seconds to
deactivate the appliance.
• Close the water tap.
• Keep the lid ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The indicator
flashes to remind you to drain
the water.
• The lid lock indicator
is on. The indicator of
button
flashes. The lid stays locked.
11
