Kraft KF-MD6104W - Инструкция по эксплуатации - Страница 39

39

USER GUIDE

AUTOMATIC WASHING MACHINE

TECHNICAL MAINTENANCE

All  electronic  components  (plug,  electric  cord,  compressor,  etc.)  must  only  be  re-

installed in certified service centers by qualified personnel.

In the event of a malfunction, you should always contact an authorized service cent-

er, specifying the type of problem and the model of your washing machine. Unqualified 
repair removes the device from warranty service. Only original spare parts can be used 
to repair the device.ли.

TROUBLESHOOTING

 During operation, if any malfunctions are detected that the consumer cannot elimi-

nate on their own, it is necessary to contact the service center for the repair of washing 
machines.

But before contacting the repair service, read this section. This list includes the most 

common cases that are not the result of poor assembly quality or poor-quality materials 
used in this device.

 ATTENTION! Before troubleshooting, you must disconnect the product from 

the  mains.  Troubleshooting  that  is  not  described  in  this  manual  should  only  be 

carried out by a qualified electrician or a competent technician.

 Malfunction 

Troubleshooting method 

Washing machine doesn't turn on.

Connect the machine to the mains. Press the "On/Off" button, then the 
"Start/Pause" button. Spread out the water supply hose.

Washing machine does not work.

Open the tap until it stops. Clean the filter on the water supply hose. 
Close the washing machine door.

The loading hatch does not open 
after washing.

The hatch lock locking system is enabled. Disconnect the washing 
machine from the power supply.

The water does not heat up.

Make sure that the cold-water wash mode is not selected.

The heating element is damaged. Contact the service center.

Water under the washing machine. Check the connection of the water supply hose.

The indicators are not highlighted.

Power supply is disrupted. Check the power connection.

The control board is damaged. Contact the service center.

Bad / weak spin.

Dose detergent according to the degree of soiling and water hardness 
(see recommendations on the detergent pack). Clean the pump filter.

The washing machine does not 
spin.

Remove and re-load the items into the drum, clean the pump.

Washing machine does not collect 
water.

1. Open the pump filter.
2. Check the water pressure.
3. Reconnect the water supply hose.
4. Close the washing machine door.
5. Check and make sure that the hose is not twisted or pinched.

Washing machine draws and drains 
water at the same time.

Check and make sure that the end of the drain hose is located above 100-
125 cm from the floor level.